EFRC8C-A EFRC8CDC-A EFRC12C-A EFRC12CDC-A LJNE8C-A LJNE12C
Installation/Care/Use Manual
USES HFC-134A REFRIGERANT
Fully Recessed Refrigerated
Fountain with FLEXI-GUARD
23
®
24
SEE FIG. 9
SEE FIG. 7
SEE FIG. 8
19, 22
25
20, 21
SEE FIG. 11
SEE FIG. 9
EFRC8C, EFRC12C EFRC8CDC, EFRC12CDC
Installer
To assure you install this model easily and correctly, PLEASE READ THESE SIMPLE
INSTRUCTIONS BEFORE STARTING THE INSTALLATION. CHECK YOUR INSTALLATION
FOR COMPLIANCE WITH PLUMBING, ELECTRICAL AND OTHER APPLICABLE CODES.
After installation, leave these instructions inside the fountain for future reference.
IMPORTANT
ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON
IMPORTANT! INSTALLER PLEASE NOTE.
THE GROUNDING OF ELECTRICAL EQUIPMENT SUCH AS TELEPHONE, COMPUTERS, ETC. TO WATER
LINES IS A COMMON PROCEDURE. THIS GROUNDING MAY BE IN THE BUILDING OR MAY OCCUR AWAY
FROM THE BUILDING. THIS GROUNDING CAN CAUSE ELECTRICAL FEEDBACK INTO A FOUNTAIN,
CREATING AN ELECTROLYSIS WHICH CAUSES A METALLIC TASTE OR AN INCREASE IN THE METAL
CONTENT OF THE WATER. THIS CONDITION IS AVOIDABLE BY USING THE PROPER MATERIALS AS
INDICATED. ANY DRAIN FITTINGS PROVIDED BY THE INSTALLER SHOULD BE MADE OF PLASTIC TO
ELECTRICALLY ISOLATE THE FOUNTAIN FROM THE BUILDING PLUMBING SYSTEM.
PAGE 1 97162C (Rev. L - 05/17)
EFRC8C-A EFRC8CDC-A EFRC12C-A EFRC12CDC-A LJNE8C-A LJNE12C
EFRC8C/EFRC12C ROUGH-IN
FINISHED FLOOR LINE
FIG. 1
LEGEND:
A = RECOMMENDED WATER SUPPLY LOCATION 3/8” O.D. UNPLATED COPPER TUBE CONNECT
STUB 1-1/2” (38mm) OUT FROM WALL, SHUT OFF BY OTHERS (BOTH SIDES).
B = RECOMMENDED LOCATION FOR WASTE OUTLET 1-1/4” O.D. DRAIN (BOTH SIDES).
C = ELECTRICAL SUPPLY LOCATION (BOTH SIDES).
NOTES:
1. THERE ARE HOLES AND KNOCKOUTS PROVIDED ON EACH SIDE OF THE MOUNTING BOX THAT
ARE INTENDED TO BE USED TO MOUNT THE BOX. USE SIX SCREWS OR BOLTS (NOT PROVIDED).
PAGE 297162C (Rev. L - 05/17)
EFRC8C-A EFRC8CDC-A EFRC12C-A EFRC12CDC-A LJNE8C-A LJNE12C
EFRC8CDC/EFRC12CDC ROUGH-IN
FINISHED FLOOR LINE
FIG. 2
LEGEND:
A = RECOMMENDED WATER SUPPLY LOCATION 3/8” O.D. UNPLATED COPPER TUBE CONNECT
STUB 1-1/2” (38mm) OUT FROM WALL, SHUT OFF BY OTHERS (LEFT SIDE ONLY).
B = RECOMMENDED LOCATION FOR WASTE OUTLET 1-1/4” O.D. DRAIN (LEFT SIDE ONLY).
C = ELECTRICAL SUPPLY LOCATION (BOTH SIDES).
*WATER AND DRAIN CONNECTIONS MUST BE MADE FROM LEFT SIDE ONLY.
NOTES:
1. THERE ARE HOLES AND KNOCKOUTS PROVIDED ON EACH SIDE OF THE MOUNTING BOX THAT
ARE INTENDED TO BE USED TO MOUNT THE BOX. USE SIX SCREWS OR BOLTS (NOT PROVIDED).
PAGE 3 97162C (Rev. L - 05/17)
EFRC8C-A EFRC8CDC-A EFRC12C-A EFRC12CDC-A LJNE8C-A LJNE12C
Note: Danger! Electric shock hazard. Disconnect power before servicing unit.
INSTALLATION INSTRUCTIONS
1. Remove shipping brace from mounting box and discard.
2. Fasten mounting box into wall cutout using screws or bolts (provided by others) through the holes or knock
outs provided on each side of the mounting box. (See Fig. 1 or 2)
3. Install fountain body to mounting box using #10 x .63” (16mm) PHSM screws and large clips provided.
4. Place refrigeration package into mounting box and connect water lines. (See Page 5 for details)
5. Water inlet is 3/8” O.D. and waste tube is 1-1/4” O.D. Contractor is to supply waste trap and service stop
valve in accordance with local codes.
6. Connecting lines to be unplated copper and thoroughly ushed to remove all foreign matter before
connecting
to refrigeration package. The furnished strainer (Item 18) should be added to the supply line.
7. Connect the refrigeration package to the supply line service stop valve. Connect supplied fountain (internal
plumbing) tubes as shown in gures 3, 4, 5, or 6. Remove any burrs from water tubes before inserting into
ttings. (See Figs. 13 and 14) DO NOT SOLDER TUBES INSERTED INTO THE STRAINER AS DAMAGE
TO THE O-RINGS MAY RESULT.
8. Electrical: Insure power supply is identical in voltage, hertz, and phase to that specied on the refrigeration
package serial plate. Never wire compressor directly to the power supply.
9. Turn water supply on and check thoroughly for leaks.
10. Release air from tank by depressing push button; a steady stream of water assures all air is removed.
11. Re-check for leaks.
12. Stream height is factory set at 35 PSI. If supply pressure varies greatly from this, turn adjustment screw on
regulator (Fig. 8). Clockwise adjustment will raise the stream height and counter-clockwise adjustment
will lower stream height. For best adjustment, stream should hit basin approximately 6-1/2” from the
bubbler.
13. Rotate fan blade on refrigeration package to insure proper clearance and free fan action.
14. Connect power supply.
15. Install grill using #8 x 1.00” (25mm) PH screws and small clips provided.
TROUBLE SHOOTING AND MAINTENANCE
1. Orice Assy: Mineral deposits on orice can cause water ow to spurt or not regulate. Mineral deposits
may be removed from orice with a small round le not over 1/8 diameter or a small diameter wire.
CAUTION: Do not le or cut orice materials.
2. Actuation of Quick Connect Water Fittings: Cooler is provided with lead-free connectors which utilize
an o-ring water seal. To remove tubing from the tting, relieve water pressure, push in on the gray collar
while pulling on the tubing (See Fig. 13). To insert tubing, push tube straight into the tting until it reaches
a positive stop, approximately 3/4”.
PAGE 497162C (Rev. L - 05/17)
EFRC8C-A EFRC8CDC-A EFRC12C-A EFRC12CDC-A LJNE8C-A LJNE12C
18
6
6
17
EFRC8C EFRC8C W/GLASS FILLER
FIG. 3 FIG. 4
18
6
16
18
6
17
17
EFRC12C EFRC12C W/GLASS FILLER
FIG. 5 FIG. 6
17
16
18
17
PAGE 5 97162C (Rev. L - 05/17)
EFRC8C-A EFRC8CDC-A EFRC12C-A EFRC12CDC-A LJNE8C-A LJNE12C
10
BASIN
Locknut
NOTE: WHEN INSTALLING REPLACEMENT BUBBLER AND PEDESTAL, TIGHEN LOCKNUT ONLY TO
HOLD PARTS SNUG IN POSITION. DO NOT OVER
TIGHTEN.
Adjustment
Screw
1
BASIN
FIG. 8FIG. 7
11
3
3
13
11
8
15
28
9
2
FIG. 9
PAGE 697162C (Rev. L - 05/17)
EFRC8C-A EFRC8CDC-A EFRC12C-A EFRC12CDC-A LJNE8C-A LJNE12C
4
FIG. 10
7
26
27
DISPENSER/
DISPOSAL
7
26 12
5
14
FIG. 11
2
16
3
2
1
WATERSENTRY® Filter Detail
WATERSENTRY® FILTER PARTS LIST
ITEM NO. PART NO.
1
2
3
51299C
98926C
51469C
(See Fig. 12)
DESCRIPTION
Filter Assy-1500 Gal.
Kit-Filter Head Fitting Includes John Guest Fittings
Assy -Filter & Bracket includes Fltr Head/Mtg Bkt/John Guest
Ftgs/Screws
FIG. 12
PAGE 7 97162C (Rev. L - 05/17)
EFRC8C-A EFRC8CDC-A EFRC12C-A EFRC12CDC-A LJNE8C-A LJNE12C
PARTS LIST
ITEM NO. PART NO. DESCRIPTION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
98536C
0000000931
40301C
40480C
40561C
40575C
62084C
62088C
56092C
75580C
70151C
70234C
56073C
40299C
40562C
50258C
50967C
61099C
1000001994
1000002162
55996C
110669443890
74070030
74070032
70567C
55001084
EFRCDF
55000881
EG23
31525028
40493C
50074C
Kit - Push Button Assy
Tailpipe - EFRC8, EFRC8F
Tailpipe - EFRC8CD
Precooler - EFRC12, EFRC12F
Precooler - EFRC12CD
Strainer/Ferrule Assy
Tube Assy - GF
Tube Assy - GF
Poly Tubing 48”(Cut to Length)
Locknut
Flat Washer Steel
Washer
Bubbler Assy
Drain - 1/2”
Glass Filler
Flat Washer Rubber
Flow Regulator Assy
Connector Assy
Kit - Tee 1/4 (3 Pack)
Kit - Union 1/4 (3 Pack)
Strainer
Screw - #10 x .63 PHSM
Screw - #8 x 1.00 PH
Speed Nut - #8
Clip - Speed
Fountain
Fountain - GF
Dispenser/Disposal
Grill
O-ring
Glass Filler
Gasket
OPERATION OF QUICK CONNECT FITTINGS
OPERATION OF QUICK CONNECT FITTINGS
SIMPLY PUSH IN
SIMPLY PUSH IN
TUBE TO ATTACH
TUBE TO ATTACH
A B C
TUBE IS SECURED
TUBE IS SECURED
IN POSITION
IN POSITION
B CA
PUSH IN COLLET
PUSH IN COLLET
TO RELEASE TUBE
TO RELEASE TUBE
PUSHING TUBE IN BEFORE
PUSHING TUBE IN BEFORE
PULLING IT OUT HELPS TO
PULLING IT OUT HELPS TO
RELEASE TUBE
RELEASE TUBE
NOTE: REMOVE ANY BURRS FROM WATER TUBES
BEFORE INSERTING INTO FITTINGS.
FIG. 13
1/4” O.D. TUBE
WATER INLET
TO COOLER
3/8” O.D. UNPLATED COPPER TUBE CONNECT
COLD WATER SUPPLY
NOTE: WATER FLOW
DIRECTION
BUILDING WATER
INLET
SERVICE STOP
(NOT FURNISHED)
FIG. 14
PRINTED IN U.S.A.
REPAIR SERVICE INFORMATION TOLL FREE NUMBER 1.800.260.6640
FOR PARTS, CONTACT YOUR LOCAL DISTRIBUTOR OR CALL 1.800.834.4816
ELKAY MANUFACTURING COMPANY • 2222 CAMDEN COURT • OAK BROOK, IL 60523 • 630.574.8484
PAGE 897162C (Rev. L - 05/17)
Loading...