Elkay ECRSP8CA Installation Manual
ECRSP8C*A ECRSPVR8C*A LCRSP8C*A
Installation/Care/Use Manual
Soft Sides® Refrigerated Fountains with FLEXI-GUARD
ECRSP8C
Installer
To assure you install this model easily and correctly, PLEASE READ
THESE SIMPLE INSTRUCTIONS BEFORE STARTING THE INSTALLATION. CHECK YOUR INSTALLATION FOR COMPLIANCE WITH
PLUMBING, ELECTRICAL AND OTHER APPLICABLE CODES. After
installation, leave these instructions inside the fountain for future reference.
®
IMPORTANT
ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON
IMPORTANT! INSTALLER PLEASE NOTE.
THE GROUNDING OF ELECTRICAL EQUIPMENT SUCH AS TELEPHONE, COMPUTERS, ETC. T O WATER LINES
IS A COMMON PROCEDURE. THIS GROUNDING MA Y BE IN THE BUILDING OR MA Y OCCUR AW A Y FROM THE
BUILDING . THIS GROUNDING CAN CAUSE ELECTRICAL FEEDBACK INTO A FOUNTAIN, CREA TING AN ELECTROLYSIS WHICH CAUSES A MET ALLIC TASTE OR AN INCREASE IN THE METAL CONTENT OF THE WA TER.
THIS CONDITION IS A VOIDABLE BY USING THE PROPER MATERIALS AS INDICA TED. ANY DRAIN FITTINGS
PROVIDED BY THE INST ALLER SHOULD BE MADE OF PLASTIC TO ELECTRICALL Y ISOLA TE THE FOUNT AIN
FROM THE BUILDING PLUMBING SYSTEM.
1/4" O.D. TUBE
WATER INLET
TO COOLER
FIG. 1
3
3/8" O.D. UNPLATED
COPPER TUBE CONNECT
COLD WATER SUPPLY
NOTE: WATER FLOW
DIRECTION
4
17
BUILDING WATER
INLET
SERVICE STOP
(NOT FURNISHED)
2
10
21
5
FIG. 2
6
NOTE: WHEN INSTALLING
REPLACEMENT BUBBLER
AND PEDESTAL, TIGHTEN
7
NUT (ITEM 9) ONLY TO
HOLD PARTS SNUG IN
POSITION. DO NOT
8
OVER TIGHTEN.
32
FIG. 3
11
18
FIG. 4
31
9
30
FIG. 5
97866C (Rev. G - 11/06)
ECRSP8C*A ECRSPVR8C*A LCRSP8C*A
LEGEND
A = 1/4" O.D. TUBE CONNECT (CHILLER W A TER OUTLET)
B = 3/8" O.D. TUBE CONNECT (CHILLER WA TER INLET) SHUT OFF V AL VE BY OTHERS
C = 1-1/4" DRAIN FURNISHED
D = ELECTRICAL INLET
97866C (Rev. G - 11/06)
FIG. 6
PAGE 2
Loading...