Elitegroup 259IA3 User Manual v.7

■■■■ appendix B agency regulatory notices

APPENDIX▼▼▼▼ B

AGENCY REGULATORY NOTICES

B-1

■■■■ appendix B agency regulatory notices

Federal Communications Commission Notice

This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:

 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and the receiver.
 Connect the equipment in to an outlet o n a cir cuit di ffer ent fr om tha t to

which the receiver is connected.

 Consult the dealer or an experienced radio or television technician

for help.

This device complies w ith Part 15 of the FCC Rules. O perati o n is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate
this equipment.

IMPORTANT NOTE:
FCC Radiation Exposure Statement:

This equipment complies w ith FCC radiati on ex posure limit s set forth for an
uncontrolled environment. End users must follow the specific operating
instructions for satisfying RF exposure compliance.
This transmitter must not be c o-loca ted or operat ing i n conjun ction w ith any
other antenna or transmitter.
"Uniwill declare that 223II0(with wireless card: Intel WM3B2200BG ) is
limited in CH1~CH11 by specified firmware controlled in USA."

Modifications

The FCC requires the user to be notified that any changes or modifications

B-2

■■■■ appendix B agency regulatory notices

made to this device that are not expressly approved by the Manufacture
may void the user’s authority to operate the equipment.

Connections to Peripheral Devices

Connections to this device m ust be ma de w ith shielde d cable s w ith metall ic
RFI/EMI connector hoods to maintain compliance with FCC Rules and
Regulations.

Declaration of Conformity

This device complies with Part 15/68 the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

European Notice

Products with the CE Marking comply with both the EMC Directive
(89/336/EEC) and the Low Voltage Directive (73/23/EEC) and R&TTE
Directive (1999/5/EC) issued by the Commission of the European
Community.
Compliance with these directives implies conformity to the following
European Norms:

 EN55022 (CISPR 22) Radio Frequency Interference
 EN50082 (IEC801-2, IEC801-3, IEC801-4) Electro-magnetic

Immunity

 EN 300 328-2, EN 300 328-1, EN 301 489-1, EN 301 489-17 (ETSI

300 328, ETSI 301 489) Electro-magnetic Compatibility and Radio
Spectrum Matter.

 TBR21 ( ETSI TBR21) Terminal Equipment.
 EN60950 (IEC950) I.T.E. Product Safety

Canadian Notice

This digital apparatus does not exceed the Class B limits for radio noise
emissions from digital apparatus as set out in the radio interference
regulations of the Canadian Department of Communications.

Le present appareil numerique nemet pas de bruits radioelectriques
depassant les limites applicables aux appareils numeriques de Classe B
prescrites dans le reglement sur le brouillage radioelectrique edicte par le
Ministere des Communications du Canada.

Power Cord Requirement

The power cord supplied with the AC adapter should match the plug and
voltage requirements for your local area. Regulatory approval for the AC

B-3