Freestanding
Assembly instructions
TIP for getting started
•It’s best to have two people to assemble a 83”/2124 mm tall solution.
•Please note that any solution used away from the wall requires feet on both sides of the solution.
•If you have foot height extenders, add them before proceeding.To install, unscrew both levelers from the foot and screw the extenders directly into base of the foot. The levelers can then be screwed into the foot height extenders and adjusted as needed to accommodate baseboards up to 2”/50 mm.
Tools needed: hammer, ladder or step stool.
Sida 1 av 5
Elfa Lumi AB
Elfagatan 5, 593 87 Västervik
Tel: +46 392-389 10 Fax: +46 392-361 25. E-mail: info@elfalumi.com
www.elfa.com
Freestanding
Assemble a single sided solution
NOTE |
|
If assembling on tile or wood, you must |
|
||
|
|
protect the floor. |
|
|
|
Assemble a single sided solution
1
A |
B |
C
Insert upright into foot
–– The holes on the side of the upright indicate the bottom of the upright.There is no front or back to the uprights.
–– Line up the upright with the slot in the foot. (Fig. A)To secure, you can tap the upright and foot together on the ground or use the mallet. Make sure the upright is all the way into the slot on the foot. (Fig. B)
–– Repeat with a second upright and foot.
Install crossbraces
–– — Place the assembled uprights/feet on the floor as shown. (Figure C)
–– — Insert crossbraces diagonally into holes at bottom of the uprights. (Figure C)
–– — Gently hold the crossbraces at the center with one hand. Using your other hand, lift one foot so that it faces up, then lift the other foot. (Figure D)
D |
Sida 2 av 5
Elfa Lumi AB
Elfagatan 5, 593 87 Västervik
Tel: +46 392-389 10 Fax: +46 392-361 25. E-mail: info@elfalumi.com
www.elfa.com