Elfa Drawer Frame User Manual

Drawer Frame

Assembly instructions

NOTE

If you don’t have a plastic mallet, you can use a hammer with a wood block to protect the
frame. If assembling on tile or wood, you must protect the floor.

Tool needed: plastic mallet

Assemble a single frame

Step 1

– Position the side panels so the frame runners face

inward.

– Using a plastic mallet, tap the bottom T-crossbars into the

bottom of each side panel.

– If combining frames, see Figure B below.

Step 2

– If using a top shelf, tap the top L-crossbars completely

into each side panel. Place adhesive strips included in
the packaging on the top L-Crossbars. Align the top shelf
with the crossbars and press firmly.

Step 3

– Slide in drawers.

– If you have other frame and drawer accessories, install

them now.

Combining drawer units

Step 1

– Assemble the top frame completely. See steps 1-2 above.

Step 2

– Assemble the bottom frame, omitting the top L-crossbars.

Step 3

– Lower the top frame onto the bottom frame. Secure by

firmly tapping each corner of the top frame until the bottom
T-crossbars are completely inserted into the bottom frame.

Step 4

– Slide in drawers.

– If you have other frame and drawer accessories, install

them now.

Elfa Lumi AB

Elfagatan 5, 593 87 Västervik
Tel: [phone] Fax: [phone]. E-mail: [e-mail]

www.elfa.com

Sida 1 av 1