Electro-Voice ZLX-BRKT Installation Note

ZLX-BRKT ZLX Wall Mount Bracket

ZLX-BRKT

en | Installation Note

Safety

!

Caution!

Due to the weight of the speaker system, it is imperative the bracket be properly secured to

the wall. The choice of fastener (not supplied) will be determined by the material and

construction of the mounting surface.

1

en 3

Electro Voice 01 | F01U285494

Installation

Installing ZLX Mounts

The ZLX Wall Mount Bracket is designed for use with all of the ZLX Series loudspeakers.
To attach the mounts to a ZLX Series loudspeaker, do the following:

1. Remove the top handle from the loudspeaker by removing the four (4) screws. Keep
these screws to assemble the upper mount.

Top Handle

Bottom Handle

Figure 2.1: Remove Handles

2. Remove the bottom handle from the loudspeaker by removing the four (4) screws. Keep
these screws to assemble the lower mount. (See Figure 2.1.)

3. Attach the upper mount to the loudspeaker with four (4) of the screws from step 1,
where the top handle was located in the up position. If you are attaching the upper
bracket to a 15 inch ZLX loudspeaker attach the upper mount in the down position.

2

ZLX-BRKT ZLX Wall Mount Bracket

01 | F01U285494 Electro Voice