Electro-Voice RE510 EDS User Manual

Key Features:

· 5/8" diameter self biased condenser capsule
offers the warmth of a larger capsule design
without sacrificing off-axis performance or
transient response.

· Low-frequency roll-off switch enables tailoring of
low-frequency response to meet application
requirements.

· Supercardioid polar pattern for superior feedback
rejection and acoustic isolation.

· Modern high-speed electronic design for
extremely low distortion, and outstanding
transient response.

· High current differential output stage can drive
long microphone cables without loss of
performance.

· Warm Grip handle for more comfortable feel.

· Multistage pop filter eliminates breath pop noises

RE510

Hand Held

Condenser Microphone

General Description:

The RE510 is a professional quality hand-held condenser
microphone that was designed especially for vocalists. The
RE510 features a 5/8" diameter capsule, advanced electronic
design, and best of all, a sound that will enhance any vocal
performance.

The high frequency response of the RE510 has been designed to
provide just the right amount of definition and “air” without the
stridency so common in other condenser vocal microphones.

The low frequency response of the RE510 in combination with
the low frequency selector switch provides versatility that was
designed to be truly useful. With the low frequency selector switch
in the rolled off position, the low end of the RE510 is tailored to
compensate for proximity effect and provides full, clean sound
without muddiness. When increased low-end is desired, placing
the low frequency selector switch in the flat position adds just
enough warmth to be noticeable, but not overbearing.

The wide bandwidth, high SPL handling capability, and low
frequency selector switch of the RE510 also make it a versatile
instrument microphone for most any application.

The low frequency selector switch is securely located beneath the
ball screen and can’t be changed inadvertently. (See figure 4)

Technical Specifications:

Generating Element: Self-Biased Condenser

Frequency Response: 40 to 20,000 Hz

Polar Pattern: Supercardioid

Sensitivity, Open Circuit Voltage, 1 KHz : -52 dBV/Pa (2.5 mV)

Output Impedance: 250 ohms

Clipping Level, 1 KHz : +2 dBV

Maximum SPL, 1 KHz: 146 dB SPL (1% THD)

Self-Noise: 22 dBA

Dynamic Range, (Maximum SPL to A 124 dB
Weighted noise level):

Signal-to-Noise Ratio: 72 dB (@ 94 dB SPL)

Polarity: Positive pressure on diaphragm produces positive voltage on pin

Power: Phantom Supply Requirement : 48 Vdc, positive at pins 2 & 3

Dimensions: Length = 7.15" (182 mm) Diameter = 2.0" (51 mm)Shank = 0.80: (20 mm)

Weight: 9.2 oz. (260 g)

2 relative to pin 3

Current Drain: Up to 10 Ma.,

Accessories Included: Stand Adaptor (Black) Soft zippered “gig” bag

1

Maximum, SPL to A Weighted Noise Level

Figure 1

Figure 3

Figure 2

12000 Portland Avenue South, Burnsville, MN 55337
Phone:[phone], Fax:[phone]

www.electrovoice.com

© Telex Communications, Inc. 7/2002

Part Number 38110-130 Rev B

Figure 4

U.S.A. and Canada only. For customer orders, contact Customer Service at:

800/392-3497 Fax: [phone]

Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:

+ 49 9421-706 0 Fax: + 49 9421-706 265

Other International locations. For customer orders, contact Customer Service at:

+ 1 952 884-4051 Fax: + 1 952 887-9212

For warranty repair or service information, contact the Service Repair department at:

800/685-2606

For technical assistance, contact Technical Support at: 866/78AUDIO

Specifications subject to change without notice.