Electronics 100 User Manual

* MODEL 100 MagnaValve ** MODEL 100 MagnaValve *

* Wheel systems
* Variable flow rates
* No moving parts
* Steel shot

* 0 - 2400 lbs/min range
* Normally closed
* Manual-open loop

systems

* Steel grit

The Model 100 MagnaValve is a normally closed magnetic valve suitable for regulation of
steel shot or grit. Used with the Model MC or 102 Power Pak the MagnaValve will provide
accurate and repeatable flow rates over a 0 - 2400 pounds-per-minute flow range.

For closed loop amperage control using 100:5 current transformer you may use model FC
amperage control. This provides closed-loopservo action with low flow alarms.

The valve construction includes a permanent magnet for normally closed operation and an
electromagnet for controlling shot flow rates. By regulating the voltage to the electromagnet,
any desired flow rate may be achieved. When power is off, the valve will hold shot due to the
permanent magnet. .

ELECTRONICS INCORPORATEDELECTRONICS INCORPORATED

SHOT PEENING TECHNOLOGY

100DATA.CDR 02/22/2003www.shotpeener.com

* MODEL 100 MagnaValve ** MODEL 100 MagnaValve *

10.0

SPECIFICATIONS

VALVE

Input : +60Vdc @ .95A

Output:0-2400 lbs/min

9.00

Indicator: Red LED = Flow

Temp. Range : 0-75)C or 32-167°F
with remote mounted valve driver

0-100°C or 32 - 212°F

Weight: 32 lbs

NOTE : Unit requires a power pak

Model MC
Model 102
Model Vd4a
or model FC control for closed
loop amps control with 100:5
current transformer

Locate valve driver remote for high
temperature applications

6.5

7.0

6.3

5.0

'O' RING SEAL 5.5 I.D'O' RING SEAL 5.5 I.D

TOP & BOTTOMTOP & BOTTOM

1.0

0.56

7.0

02/22/2003

CABLE: 2 Conductor Shielded
18 AWG or Equivalent
Connect shield at control only

100DATA.CDR 02/22/2003100DATA.CDR

56790 Magnetic Drive Mishawaka, In. USA 46545 [phone]56790 Magnetic Drive Mishawaka, In. USA 46545 [phone]

1/2" CONDUIT HUB1/2" CONDUIT HUB

BOTH SIDESBOTH SIDES

To Controller

To Valve

1. Red

2. Black

3. Orange

4. Brown

VD7 Valve Driver