Installation
• This appliance is heavy. Care should be
taken when moving it.
• All packing and transit bolts must be removed before use. Serious damage can
occur to the product and to property if
this is not adhered to. See relevant section in the user manual.
• This appliance is free standing only. DO
NOT build it in under a counter and DO
NOT remove the worktop for any reason.
• After having installed the appliance,
check that it is not standing on the inlet
and drain hose and the worktop is not
pressing the electrical supply cable
against the wall.
• Install the appliance on a flat hard floor.
• Never place cardboard, wood or similar
materials under the appliance to compensate for any unevenness in the floor.
• If the appliance is situated on a carpeted
floor, please adjust the feet in order to allow air to circulate freely under the appliance.
• Check that the appliance does not touch
the wall or other kitchen units.
• This appliance must be connected to
a cold water supply.
• Do not use the hose from your previous
appliance to connect to water supply. Always use the hose supplied with the appliance.
• The inlet hose must not be lengthened. If
it is too short and you do not wish to
move the tap, you will have to purchase a
new, longer hose specially designed for
this type of use.
• Always be sure, that there is no water leakage from hoses and their connections after the installation.
• If the appliance is installed in a location
subject to frost, please read the “Frost precaution” chapter. Manufacturer decline
any responsibility for freezing damages.
• Any plumbing work required to install this
appliance should be carried out by a qualified plumber or competent person.
• Any electrical work required to install this
appliance should be carried out by a qualified electrician or competent person.
Use
• This appliance is designed for domestic
use. It must not be used for purposes other than those for which it was designed.
• Only wash fabrics which are designed to
be machine washed. Follow the instructions on each garment label.
• Do not overload the appliance. See the
"Washing Programme Chart".
• Before washing, ensure that all pockets
are empty and buttons and zips are fastened. Avoid washing frayed or torn articles and treat stains such as paint, ink,
rust, and grass before washing. Underwired bras must NOT be machine washed.
• The detergent dispenser drawer is provided with an insert for liquid detergent. Do
not use the insert downwards for gelatinous detergents, with programmes including prewash, with the delay start option.
In all these cases you can use metering
balls or sachets provided with the detergent, Take out the metering aid at the
end of the washing cycle.
• Garments which have been in contact
with volatile petroleum products should
not be machine washed. If volatile cleaning fluids are used, care should be taken
to ensure that the fluid is removed from
the garment before placing in the appliance.
• Never pull the power supply cable to remove the plug from the socket; always
take hold of the plug itself.
• Never use the appliance if the power supply cable, the control panel, the working
surface or the base are damaged so that
the inside of the appliance is accessible.
Child safety
• This appliance is not intended for use by
persons (including children) with reduced
physical sensory or mental capabilities or
lack of experience and knowledge unless
they have been given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
• Children should be supervised to ensure
that they do not play with the appliance.
• The packaging components (e.g. plastic
film, polystyrene) can be dangerous to children - danger of suffocation! Keep them
out of children’s reach.
electrolux 3