Electrolux E36GC76EPS, E48GC76EPS Installation Guide

Installation Instructions
Slide In Gas Cooktop
Safety
(MPORTANTSAFETY(NSTRUCT(ONS
..............................................m [] [] m [] [] [] m [] [] [] m [] [] [] m [] [] [] m [] []
))))))))))))))))))))))))))))))))))))))))))))))))))))))))))))_i!i¸!!iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii)
Safety Precautions
Do notattemptto install oroperateyour unit until you have readthesafety precautions in this manual. Safety itemsthroughoutthis manual are labeled with a Warning or Caution based onthe risktype.
Definitions
_Thisisthesafetyalertsymbol. Itisusedtoalertyoutopotentialpersonal
iniuiyhazards. Obeyallsafetymessagesthatfollowthissymboltoavoid possible injuryordeath.
Safety 3
SAFETYPRECAUTIONS
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
,,%,WARNING
Read all instructions before using the appliance.
Improper installation, adjustment, alteration, service, or maintenance can cause
personal injury or property damage. Refer to these instructions and the
accompanying Use & Care Manual. For assistance or additional information, consult a qualified installer, service agency, manufacturer (dealer), or the gas
supplier.
For your safety: Do not obstruct the flow of combustion and ventilation air to the unit.
Keep appliance area clear and free from combustible material, gasoline and other flammable vapors and liquids.
Do not use or attempt to use this appliance in the event of a power failure.
This unit is designed as a cooking appliance. Never use it for warming or heating
a room.
This appliance must be installed with the gas pressure regulator supplied with it.
Disconnect the electrical supply before installing or servicing the appliance.
This appliance must be grounded. Connect only to a properly grounded
electrical supply. Refer to "Electrical Requirements".
Install or locate this appliance only in accordance with these installation
instructions.
Use this appliance only for its intended use as described in this manual. Do not
use corrosive chemicals or vapors in this appliance. This type of appliance is not
designed for industrial or laboratory use.
As with any appliance, close supervision is necessary when used by children.
Do not operate this appliance if it has a damaged electrical cord, plug, conduit or
wires, if it is not working properly, or if it has been damaged or dropped.
This appliance should be installed and serviced only by qualified service
personnel.
Some products, such as whole eggs, and sealed containers, such as closed glass
jars, may explode and should not be heated on this cooktop.
Safety
Finding Information
READANDSAVETHESEINSTRUCTIONS
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
For toll-free telephone support in the U.S. and Canada: 1-877- 4ELECTROLUX (1-877-435-3287)
For online support and Internet product information: www.electroluxusa.com
@2005 Eiectroiux Home Products, Inc. Post Office Box 212378, Augusta, Georgia 30917, USA All rights reserved. Printed in the USA
Finding Information
TABLEOFCONTENTS
Safety.....................................................................2
Definitions...........................................................2
ImportantSafetyInstructions...............................2
SafetyPrecautions .............................................. 3
Finding Information............................................5
PleaseReadAndSaveThisGuide....................5
Questions?..........................................................5
TableOfContents...............................................6
Preparing for Installation ...................................7
VerifyingPackageContents................................7
Cabinet/CounteropPreparation..........................7
MakingtheGaslElectricConnection...............11
Requirements...................................................11
L,P,GasConversion........................................12
Installation ..........................................................14
...........................................................................................................................InstallingtheCooktop........................................14
ConnectingtheGas..........................................14
GasandElectricRequirementsTable...............15
InstallingtheBurnerComponents.....................16
MakingtheElectricalConnection......................17
Operation............................................................18
VerifyingtheOperation......................................18
PreparingforInstallation
VERIFYPACKAGECONTENTS
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
[] [] [] [] [] []
Literature Pack
Bolts/Washers
Burner Grate Pack
Burner Set
Gas Pressure Regulator
Burner Cap Pack
Griddle
Simmer Plate
Wok Stand
Stainless Steel Cleaner
LP Conversion Kit
CABINET/COUNTER'FOPPREPARATION
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
The installation of this built-in appliance must be completed by a qualified appliance technician or contractor. Proper installation is the owner's responsibility.
Carefully check the location where the cooktop is to be installed. The cooktop should be placed for convenient access, but away from drafts that may be caused
by open doors and windows or by HVAC duct outlets. Make certain that gas and electrical power can be provided in the selected locations. Plan the installation so that all minimum clearances are met or exceeded. Dimensions shown provide minimum clearances, unless otherwise noted.
Preparing for Installation
Figure 1
Plan the installation so that the electrical connection, gas shut-off valve, and pressure regulator are accessible from the front of the cabinet and so that all of the
E36GC76EPS: 36" (914mm) Minimum E48GC76EPS: 48" (1219mm) Minimum
Hood
Min to 5,8" (16turn) Overhar_g, both sides
combustib]e side / _,2" (38ram)
wall both sides Typical Cour_te_op
Q ®
® ®
6 I
E48GC76EPS 30" (762mm)
V
Minimum
...... 30" {762turn)
(457mm}
/8" J
1
H97mm)
7 3_4" ]
-- (g14mm)
/5 1_2rr
(393mm) 28 /4"
(7/7mm)
/254mm)
/0" J
T
minimum required dimensions are provided. Dimensions apply to both
models unless otherwise
stated (see Figure 1). Locate the electrical supply box
within reach of the included 48 inch long flexible cord so
the connection is accessible when the cooktop is in place.
PreparingforInstallation
Figure 3
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
Countertop Cut-out Dimensions
(when Cooktop is to be installed with Downdraft Vent Hood
36" model: E36DD75ESS; 48" model: E48DD75SS)
Vertical non-combustible surface rear wall .,_ E36GC76EPS-33 7/8" (860mm) I_
"_. _ E48GC76EPS - 43 1/2" (1105mm) z _['_-. Backsplash
_1 _ I i I Max.3/4" (19ram) _--_,
/ = Ii / _[--]213/_+; ,
........ I i21 3/8" Ii / /'_ 1_7_mm i
...... (543mm) Ii | 1/4" (6mm) ",, _ t "_
(716r_m) I i I Ii / Min. flatledge _ T I i ,,"
3" (76ram)
-- _ _E36 GC76EPS-34 3/4'+ (883mm)/ I
5/8" (16ram) E48GC76EPS- 46 3/4" (1188mm) --_
Figure 4 walls above the range
'_-_ E36GC76EPS - 36" (914rnm) _ _._ 6'+ (152mm) Min.
E48GC76EPS - 48" (1219mm) to combustible side
(both sides)
iiiiiiiiiiii
OPTIONAL STAINLESS
STEEL BACKSPLASH
Ea6GC76EPS: ACCBD09 4SS_
E#SDC76EPS:
ACCBGO9 a6SI
Preparing for Installation
Overall Dimensions - Side Views
Clearance to Combustible Rear Wall
COMBUSTIBLE REAR
FWALL MATERIAL
TOP OF FINISHED COUNTER_
743E197mm]
Overall Dimensions
Cutout Dimensions _ ............. _:_
Clearance to Combusti
Ee4r_m]
Figure 5
Optional 9" stainless steel backsplash (attaches to wall)
Side inset s/8"
2 W' min. required distance between rearedgeofcooktop
andnearest combustible surface abovecountertop.*
* If 2 W' clearance can not be maintained, then optional
stainless steel backsplash or noncombustible backsplash material must be used - otherwise this installation
will require custom cabinet andcountertop dimensions.
/
Figure 6
I,_3 Y2"
Openingto routegas /
andelectricalsupply
Cooktop Model A B C D
E48GC76EPS 48" Min. 48" 46" 48"
E36GC76EPS 36" Min. 36" 34sA'' 36"
Suppo_
pla_orm
Dimensions
10" min. to nearest combustible wall
(either side of unit)
t/2" typical
countertop edge
Loading...
+ 22 hidden pages