To enable you to use your new hob efficiently and safely, please read this
instruction book carefully before installing or using the appliance, and retain
for future reference. Should the hob be transferred to a new owner please
ensure this instruction book is left with the appliance in order that the new
owner can get to know the functions of the appliance and the relevant
warnings.
If you require further assistance or advice, please contact our Customer Care
Department either by letter or telephone:
Customer Care Department
AEG Domestic Appliances
55-77 High Street
Slough
SL1 1DZ
Tel: 08705 350350
2
Table of contents
ContentsPage no
For the user
Your new appliance ...................................................................................... 2
Safety information ........................................................................................ 4
Description of the product ......................................................................... 5
These warnings are provided in the
interests of your safety. Ensure you
fully understand them before installing
or using the appliance. Your safety is of
paramount importance. If you are
unsure about the meaning of these
warnings contact the Customer Care
Department for assistance.
Installing
Do not install the hob if the ceramic
glass is damaged or cracked.
This hob must be installed according to
the instructions supplied. Any electrical
installation work must be undertaken
by a qualified electrician/ competent
person.
Do not alter the specifications or
attempt to modify the appliance in any
way.
During Use
The hob is intended for domestic
cooking only. It is not designed for
commercial/industrial purposes.
Ensure that all the control knobs are in
the OFF position when not in use.
Never use plastic or aluminum dishes
on the hob.
Never leave the hob unattended while
deep fat frying, or heating fats and oils.
Child Safety
Young children must not be allowed to
tamper with the hob or play with the
controls.
The hob gets hot when it is in use.
Children should be kept away until the
hob has cooled.
Maintenance and Cleaning
Only clean this hob in accordance with
the instructions given in this book.
Service
Repairs carried out by inexperienced
persons may cause injury or serious
malfunction of the appliance. Repairs
must only be carried out by a
qualified/competent person. Contact
your local AEG Service Force Centre.
Disposal
Make the hob unusable by cutting off
the cable.
Do not use the hob if it is damaged in
any way. If a fault or crack becomes
visible, disconnect the hob immediately
from the electricity supply and contact
your local AEG Service Force Centre.
Dispose of any packaging material and
old appliances at an authorised
disposal site.
4
Description of the product
Control knobs
CHEC
Control panel
Control knobs for operations
5
Ceramic glass surface
The ceramic glass surface has four
cooking zones. When a zone is
turned on, it will illuminate at
various intervals depending on the
heat setting selected. Even at the
highest setting the zone is
disconnected occasionally to ensure
that the surface is not over-heated.
The glass is hard, and has been
tempered to withstand heat, cold
and temperature shocks. But like all
glass it is sensitive to impact. Do
not stand on the ceramic glass
surface.
At the front of the ceramic
glasssurface in the middle there are
four fields. Each field corresponds
to a cooking zone. When using a
zone, the field concerned will show
which CHEC function you are
using and the setting at which you
have set the zone.
means that you do not have to
adjust the heat constantly. CHEC
control provides the zones with the
following functions:
Automatic disconnection of
“forgotten” zones.
AUTOMAX at all settings.
Setting of large zone on
double zones.
Child safety device on zones.
Residual heat indicator
When you switch off a zone, an
"H" in the display indicates that the
zone is still hot. The residual heat
indicator will continue to be
illuminated until the zone reaches a
temperature of approx. 80˚C.
Cooking zones
There are three single zones and
one double zone.
CHEC control
Information about how to use the
CHEC control function can be
found in the section entitled
“Operation instructions”. The
CHEC control function allows
electronic control of the zones.
CHEC control enables you to set
the heat with great precision, which
6
Before use
Connection of child safety
device on zones
Turn the 2 control buttons to
at the same time.
The display will show:
When you turn on a zone the display
will show:
S A
To turn on a zone, turn the 2 control
buttons to at the same time. You
must then activate one of the zones
within 10 seconds.
The light under the symbol
in the display will disappear.
You can disconnect the child safety
device permanently as follows:
1. Turn the 2 control buttons to
and return to 0.
2. Turn one of the 2 control buttons
immediately to .
F E
7
Protection of the glass
ceramic surface
A protective film should be applied
to the glass ceramic surface before
use. This will make it easier to
clean the surface, as well as
preventing substances from being
burnt onto the surface.
This is what to do:
1. Pour a few drops of ceramic
cleaning detergent such as
vitroclen onto a piece
of kitchen roll and rub the
detergent into the entire surface.
2. Polish the surface with a clean
cloth until it is dry.
8
Operating instructions
Switch symbols (to the left)
control for regulating the small
cooking zone at the rear
control for regulating the double
cooking zone at the front.
control for regulating the large
cooking zone at the rear
control for regulating the small
cooking zone at the front.
Regulating
The regulation of heat is step-free for all
plates on a scale from 1 to 9.
“1”Represents lowest heat
“9” Represents maximum heat.
“0”Represents “OFF”.
Double cooking zone
Small circle: When you control on the
cooking section it will always be the
small circle that is controled on. Choose
the wanted temperature.
From small to big circle (both circles
are on): Turn the button past “0”. T urn
back to the wanted temperature.
From big to small circle: Turn the
button back to “0”. Control on again and
choose the wanted temperature.
9
Residual-Heat indicator
When you switch off a zone, an "H" in
the display indicates that the zone is
still hot. The residual heat indicator
will continue to be illuminated as long
as the temperature exceeds 80˚C.
Cooking zones
The control knobs are continuously
adjustable from 1 to 9 (9 is the highest
setting). There is AUTOMAX control
of all settings, enabling you to set the
setting required from the outset. Please
see the table of settings. The 14 and 18
cm zones are suitable for boiling and
preparing small and medium-sized
portions. The 21 cm zone is suitable
for frying, and for boiling and
preparing large portions. The 12 cm
zone is not suitable for boiling, but can
be used for melting, simmering and the
preparation of gravy, sauces etc. which
must not curdle.
10
Loading...
+ 22 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.