Electrolux ACC096 User Manual

INSTALLATION MANUAL

REFRIGERATOR DOOR REVERSAL KIT

Models: ETB2102PE, ETB2302PE, ETB2602PE, ETB3202PE, ETB3502PE, EBB2602PA, EBB3202PA, EBB3502PA, WBB3400PA, WBB3400WA, WBB3700PA, WBB3700WA, HTB2300PC,
HTB3200PC, HTB3500PC, WTB2300WC, WTB2300PC, WTB2500WC, WTB2500PC, WTB2800WC, WTB2800PC, WTB3400WC, WTB3400PC, WTB3700WC, WTB3700PC.
This installation manual is applicable to both top freezer (top mount) and bottom freezer (bottom mount).

KIT CONTENTS

DESCRIPTION QTY

Cover top cabinet wh GR
Cover top cabinet wh WHT11

Hinge top cover left GR
Hinge top cover left WHT

Hinge top left 1

Hinge centre left 1

Hinge bottom base left 1

Door auto closer LH 2

Screw centre hinge 2

Cover screw mullion WH GR
Cover screw mullion WH WHT2 2

NOTE: Keep kit parts separate from other parts as you

disassemble them to avoid mix-ups.This installation manual
is applicable to both top freezer and bottom freezer models.

TOOLS YOU WILL NEED (not supplied)

Phillips head screwdriver

"

16

8mm (5/

) hex head socket

INSTRUCTIONS

1. Ensure refrigerator is empty of all loose items and
unplugged from power source.

1
1

2. Store power cord next to motor to prevent damage.
Check for water in drain pan and remove any water
with a cloth or sponge if necessary.

drain pan

motor

3. Lay the refrigerator on its back.

rear view of
refrigerator

WARNING

Your refrigerator is heavy – you may need assistance.

bottom door

7. Remove top door by opening 45º and gently slide off
hinge. Set door aside to prevent damage.

8. Unscrew 2 centre hinge screws. Remove the cover
hole mullion with plastic lever.

cover hole
mullion

screws

9. Remove RH centre hinge by lifting the door slightly
and sliding hinge out of the door.

1

2

WARNING

Electrolux/Westinghouse takes no responsibility for
incorrectly assembled doors leading to injury or malfunction

CAUTION

Refrigerator must stand for 30 minutes prior to connecting
to power supply to ensure system functions correctly.

IMPORTANT

All hinge screws require tightening to a torque setting
of 5-10Nm.

FRIDGE DESCRIPTION

Top view of right hand hinge cabinet

1

4
3

Bottom view of right hand hinge cabinet

5

Top freezer Bottom freezer

4. Remove the hinge cover with a soft plastic lever.

2

6

5. Remove the LH cap with a soft plastic lever.

6. Unscrew 3 x 8mm top hinge screws and remove RH
top hinge. Do not discard screws.

top door

10. Remove bottom door by opening 45º and gently
slide off hinge. Set door aside to prevent damage.

11. Remove the cover door from top door and assemble it
on the other side. Remove the RH door auto closer and
replace with LH door auto closer (kit content) on the
other side. Repeat the same step with bottom door.

cover door

door auto
closer LH

1 Cover top cabinet WH

2 Hinge top right and hinge top

cover right

3 Cover hole mullion

4 Hinge centre right

and screws

5 Adjustable foot

6 Hinge bottom assembly right

door auto
closer RH

Follow Step 12 – 16 for model WTB2300 and
WTB2500 where fitted with kick plate. For other
models without kick plate please skip to Step 17
and onwards.

12.

Unscrew the four screws indicated below to remove
the side kickplates.

19. Place the bottom hinge LH (kit content) onto the
cabinet, placing it down then towards cabinet to
install. Replace the screw.

1

26. Ensure that the edges of the doors are parallel with
the sides of the cabinet.

13. Unscrew the bottom hinge screw shown, pull the
hinge away from cabinet then up to remove.

1

2

14. Place the bottom hinge LH (kit content) onto the
cabinet, placing it down then towards cabinet to
install. Replace the screw.

1

2

15. Remove the spacer from the kickplate and clip to the
other side.

2

20. Replace the hinge foot onto the LH bottom hinge
and tighten with screw.

21. Replace the bottom door by holding at 45º and
gently slide onto the bottom hinge and close the
door.

22. Replace LH centre hinge (kit content) by lifting the
door slightly and sliding hinge into the door and
placing the door down again.

27. Ensure that the bottom door and the top door have
a parallel gap.

28. Fully tighten the LH top hinge to the cabinet until the
hinge is secure.

29. Clip the LH hinge cover (kit content) over LH
top hinge.

16. Assemble the kickplate to the refrigerator using the
four screws.

Skip Steps 17 to 20 and follow from Step 21 & onwards.

17. Unscrew the hinge foot using phillips head
screwdriver and unscrew foot on opposite side. Do
not discard.

18. Unscrew the bottom hinge screw shown, pull the
hinge away from cabinet then up to remove.

1

2

1

2

23.

Insert 2 x 8 mm screws from existing centre hinge
into the LH centre hinge, tighten the screw until the
bracket is secured. Assemble 2 phillips head screws
and covers (kit content) on the other side as shown
below.

screws
& covers

screws

24. Replace the top door by holding at 45º and gently
slide onto the centre hinge and close the door.

25. Slide the LH top hinge (kit content) into the door,

loosely screw the 3 x 8mm screws from the existing
top hinge in the cabinet.

30. Insert the RH top hinge hole cap (Kit content) in the
cabinet as shown.

31. Stand the refrigerator upright.

WARNING

Your refrigerator is heavy – you may need assistance.

33. Level the cabinet by adjusting the foot.

** It is recommended to apply a small amount of silicone

grease (Molykote EM-50L or equivalent – not provided with
kit) on all pivoting pin of left hand hinges for lubrication.

For further information on these appliances, or to obtain detailed dimension and installation information, call into your Retailer, phone or email our Customer Care team or visit our website:

AUSTRALIA
phone: [phone]
fax: [phone]
email: [e-mail]
web: www.westinghouse.com.au

© 2014 Electrolux Home Products Pty Ltd ABN 51 004 762 341 GMAN_DOORREV_May14 Part number: 807557701

NEW ZEALAND
phone: [phone]
fax: [phone]
email: [e-mail]
web: www.westinghouse.co.nz

MALAYSIA
domestic toll free: 1300 881 122
fax: [phone]
email: [e-mail]

VIETNAM
domestic toll free: 1800 58 88 99
phone: [phone]
fax: [phone]
email: [e-mail]

SINGAPORE
customer care hotline: [phone]

HONG KONG
phone: [phone]
email: [e-mail]
web: www.electrolux.com.hk