Important Safety Information
You MUST read these warnings carefully before installing or using the hob. If
you need assistance, contact our Customer Care Department on 08705 350350
Installation
z This hob must be installed by qualified personnel, according to the manufacturer’s
instructions and to the relevant British Standards.
z Any gas installation must be carried out by a registered CORGI installer.
z Remove all packaging before using the hob.
z Ensure that the gas and electrical supply complies with the type stated on the rating
plate, located near the gas supply pipe.
z Do not attempt to modify the hob in any way.
Child Safety
z This hob is designed to be operated by adults. Do not allow children to play near or
with the hob.
z The hob gets hot when it is in use. Children should be kept away until it has cooled.
z Children can also injure themselves by pulling pans or pots off the hob.
During Use
z This hob is intended for domestic cooking only. It is not designed for commercial or
industrial purposes.
z It is important to note that the plate may smoke a little and produce a slightly unpleasant
odour when used for the first time. This is quite normal and will disappear after a few
minutes.
z Take care when frying food in hot oil or fat, as the overheated splashes could easily
ignite.
z Never leave the plates on without a pan on them or with an empty pan on them.
z Never use the hob as a worktop.
3
z Never attempt to repair the hob! Repairs carried out by unexperienced persons can
cause damage or injuries. This hob should only be repaired or serviced by an
authorised Service Engineer and only genuine approved spare parts should be
used.
z This hob can be built-in in furniture units placed near higher walls or units, provided
that one of the sides is adjacent to an unit with the same height.
z Do not use this hob if it is in contact with water. Do not operate the hob with wet hands.
z Ensure the control knobs are in the ‘OFF’ position when not in use.
z When using other electrical appliances, ensure the cable does not come into contact
with the hot surfaces of the cooking appliance.
z Unstable or misshapen pans should not be used on the hob as unstable pans can
cause an accident by tipping or spillage.
z Never leave the hob unattended when cooking with oil and fats.
z Never use plastic or aluminium foil dishes on the hob.
z Perishable food, plastic items and areosols may be affected by heat and should not
be stored above or below the hob unit.
Service
z This hob should only be repaired or serviced by an authorised Service Engineer and
only genuine approved spare parts should be used.
Environmental Information
U
z After installation, please dispose of the packaging with due regard to safety and the
environment.
z When disposing of an old appliance, make it unusable, by cutting off the cable.
Keep this instruction book for future reference and ensure it is passed on to
any new owner.
These instructions are only valid for countries whose identification symbols are shown on
the cover of this instruction booklet and on the appliance itself.
4
Contents
For the user
Important Safety Information 3
Description of the Hob 6
Operation 7
Hints and Tips 9
Maintenance and Cleaning 10
Something Not Working? 11
Service and Spare Parts 12
Customer Care 12
Guarantee Conditions 13
For the installer
Instructions for the Installer 14
Important safety requirements 14
Installation 15
Cut Out Size 15
Electrical connections 17
Wiring diagram 18
Guide to Use the instructions
The following symbols will be found in the text to guide you throughout the Instructions:
Safety Instructions
Step by step instructions for an operation
)
Hints and Tips
U
Environmental information
This appliance is manufactured according to the following EEC directives:
73/23 EEC - 90/683 EEC - 93/68 EEC 89/336 EEC - 90/396 EEC,
current edition.
5
Description of the Hob
Back Left
Hotplate
Front Left
Hotplate
Back Right
Hotplate
Back Left Hotplate
Control Knob
Front Right
Hotplate
Operating Pilot Lamp
Front Right Hotplate
Front Left Hotplate
Control Knob
Back Right Hotplate
Control Knob
Control Knob
INSTALLATION
The hob must be installed according to the instructions supplied.
The hob must be installed by qualified personnel to the relevant British Standards.
Please, ensure that, once the hob is installed, it is easily accessible for the engineer in the
event of a breakdown.
WHEN THE HOB IS FIRST INSTALLED
Once the hob has been installed, it is important to remove any protective materials, which
were put on in the factory.
6