Electro-Harmonix Wiggler Instruction Manual

WIGGLER

All tube Vibrato and Tremolo

Congratulations on your purchase of the Wiggler! The Wiggler is a
warm sounding Vibrato/Tremolo pedal with an All Tube signal path
using two premium 12AX7WB vacuum tubes. Carefully reading
these instructions will ensure that you will get the most out of your
Wiggler.

Included with the Wiggler is a unique 12VAC/1000mA adaptor. Use

only the adaptor supplied. Using any other adaptor can cause harm to you,
the Wiggler and the adaptor.

WARNING: There are extremely high voltages in the Wiggler even when it is
unplugged – DO NOT OPEN UP THE WIGGLER!

- CONTROLS -

Tremolo/Vibrato Switch – Selects the type of effect.

Vibrato Mode Switch – When the Wiggler is in Vibrato mode, the
VIBRATO MODE switch will select between four different types of Vibrato

sounds: LOOZ, HAMM, ACEY, and WURL. This switch has no function
when the unit is in Tremolo mode.

RATE Knob – Adjusts the speed of modulation for the Vibrato or Tremolo.
As the RATE knob is turned from the Counter-Clockwise (minimum) position
to the Clockwise (maximum) position, the rate of modulation will increase.

INTENSITY Knob – Adjusts the amount of Vibrato or Tremolo that will
effect your signal. As the INTENSITY knob is turned from the Counter­Clockwise (minimum) position to the Clockwise (maximum) position, the
amount of the effect will increase.

VOLUME Knob – Adjusts the level of the OUTPUT signal.

RATE LED – Blinks at the same rate that the effect modulates.

STATUS LED – Lights up when the Tube Wiggler effect is engaged. If the

STATUS led is off, the unit is in TRUE BYPASS mode. The Footswitch
engages/disengages the effect.