Electro Harmonix Small Clone User manual

SMALL CLONE

FULL CHORUS

-OPERATING INSTRUCTIONS-

The Small Clone is a compact battery operated Chorus device that features
DEPTH and RATE controls with an LED indicator.

To produce the Chorus effect, The Small Clone bends the frequency slightly
from the input source and mixes this altered signal with some direct
unaffected signal. The combination produces a doubling effect.

Plug your guitar into the INPUT jack and your amp into the OUTPUT.
Please note that as long as a plug is inserted into the INPUT, a drain is
placed on the connected battery. It is recommended that you disconnect the
INPUT jack when the unit is not in use to increase battery life.

The DEPTH switch controls the amount of frequency change that occurs in
the altered signal. The rate of alteration between raising and lowering the
frequency is controlled by the RATE knob.

The red LED indicates when the effect is switched on. The footswitch
engages and disengages the Chorus effect.

The Small Clone is powered from a 9V battery or you can use an optional
9VDC AC Adapter capable of delivering at least 25mA to the black power jack
on the rear of the unit. We recommend the EHX 9.6DC-200 AC ADAPTER.
The AC Adapter must have a center negative plug that fits a 2.1mm center
pin. The battery may be left in or taken out when using an AC Adapter. The
Small Clone has a current draw of approximately 12mA at 9VDC. The
external power supply should not exceed 10VDC.

- WARRANTY INFORMATION -

Please register online at http://www.ehx.com/product-registration or
complete and return the enclosed warranty card within 10 days of purchase.
Electro-Harmonix will repair or replace, at its discretion, a product that fails
to operate due to defects in materials or workmanship for a period of one
year from date of purchase. This applies only to original purchasers who
have bought their product from an authorized Electro-Harmonix retailer.
Repaired or replaced units will then be warranted for the unexpired portion
of the original warranty term.

If you should need to return your unit for service within the warranty period,
please contact the appropriate office listed below. Customers outside the
regions listed below, please contact EHX Customer Service for information on
warranty repairs at [e-mail] or [phone]. USA and Canadian
customers: please obtain a Return Authorization Number (RA#) from

EHX Customer Service before returning your product. Include  with your
returned unit  a written description of the problem as well as your name,

address, telephone number, e-mail address, RA# and a copy of your receipt
clearly showing the purchase date.

United States & Canada Europe

EHX CUSTOMER SERVICE JOHN WILLIAMS
ELECTRO-HARMONIX ELECTRO-HARMONIX UK
c/o NEW SENSOR CORP. 13 CWMDONKIN TERRACE
55-01 2ND STREET SWANSEA SA2 0RQ
LONG ISLAND CITY, NY 11101 UNITED KINGDOM

Tel: [phone] Tel: [phone]
Email: [e-mail] Email: [e-mail]

Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.
Modifications not expressly approved by the manufacturer could void the user's
authority to operate the equipment under FCC rules.