Elation RDMS6 User Instruction

User's Instruction

RDMS6

6 Way RDM Splitter

RDMOUT1-6

12

3

4

5

6

1=Ground
2=Data­3=Data+
4,5=NC

6Way RDMBoost

RDMS6

RDM THRU

ACIN

FUSE

RDM IN

Madein P.R.C.

ACIN:

Fuse:

100-240V~50/60Hz,1A Max.

F1A250V 5x20mm

RoHS

Signal

Power

LinkOut/

Terminate

RDM DMX

CAUTION!

DONOT OPEN

Riskof Electric Shock

Nepas ouvrir. Risque

dechoc electrique

Warning:Thisapparatus

mustbe earthed

1=Ground
2=Data-
3=Data+
4,5=NC

Product Descriptions

Technical Specifications

POWER INPUT

RDM IN/THRU,RDM OUTPUT
DIMENSIONS
WEIGHT

.................................................................................................................................AC 100~240V

.......................................................................................................Via 5-pin terminal

............................................................................................................................264x133.3x120mm

.......................................................................................................................................................1.45Kg

POWER CONSUMPTION ..................................................................................................................................5W

This is a 6 way RMD splitter, features one RDM IN/THRU and 6 RDM OUTPUTs. This unit takes the incoming
RDM/DMX signal and splits the signal into six separate OUTPUT channels. Each OUTPUT and the IN/THRU
are completely electronically isolated from each other, all six OUTPUT ports have independent output driver to
boost the RDM/DMX signal.

Operation Guide

Set the RDM/DMX switch as "DMX", the RDMS6 applies to DMX signal input only and the Input/Output
Signal is mono-directional communication.

Set the RDM/DMX switch as "RDM", the RDMS6 applies to DMX or RDM signal input and the Input/Output
Signal is bidirectional communication.

Data Cable (DMX Cable) Requirements:

The RDMS6 is controlled via DMX-512 protocol and your DMX controller requires a standard 3-pin terminal
connector for data input and data output. Connect the RDMS6 and your fixtures together using standard 3­pin DMX cables.

DMX Signal Cable. 120 ohm impedance DMX signal cable be used for signal connection.MUST

The signal indicator will blink when RDMS6 detects any signal inputs.

24-004-3067-00

Rev1.0

While need one RDMS6 in system only for operation(thus the RDM Thru needn't connect to the next
RDMS6), the user may move the end-switch to terminal end for connecting to end-resistor. Regarding the
other status, the end-switch should be disconnected to put through the RDM In and RDM Thru.

1

2
3
4

5
6
7

8

9

1.RDM OUT 1~6: via 3-pin XLR connector.

2.RDM Thru: via 3-pin XLR connector.

3.RDM IN: via 3-pin XLR connector.

4.RDM/DMX switch: selects signal inputs.

5.Link Out/Terminate switch: selects Link Out or Terminate.

6.Power In: Inputs a power of 100~240V AC,50/60Hz.

7.Fuse:

8.Power Indicator: It will light when contacts to the suitable power source.

9.Signal Indicator: it will blink when RB-6 TS detects any signal inputs.

Function Descriptions