EKWB EK-FC WX9100 PRO Service Manual

EK-FC
WX9100 PRO

GPU WATER BLOCK

INSTALLATION MANUAL

This product is compatible with Radeon Pro WX 9100 graphics card.
It is intended for installation only by expert users. Please consult with
a qualified technician for installation. Improper installation may result
in damage to your equipment. EK Water Blocks assumes no liability
whatsoever, expressed or implied, for the use of these products, nor
their installation. The following instructions are subject to change
without notice. Please visit our web site at www.ekwb.com for updates.
Before installation of this product please read important notice,
disclosure and warranty conditions printed on the back of the box.

Before you start using this product please follow these basic
guidelines:

Please carefully read the manual throughly before beginning
with the installation process!

Please remove your graphics card from computer to assure
safest mounting process in order to prevent any possible
damages to your GPU and/or graphics card circuit board(PCB).

The EK fittings require only a small amount of force to screw
them firmly in place since the liquid seal is ensured by the
rubber O-ring gaskets.

Do not use pure dist illed water! For best results EK recommends
the use of EK-CyroFuel coolants!

- 2 -

TABLE OF CONTENT

PREPARING YOUR GRAPHICS CARD 4
INSTALLING THE WATER BLOCK 6
CHECKING FOR CONTACTS 8
INSTALLATION OF FITTINGS AND TUBING 8
INSERTING THE CARD IN YOUR PC CASE 9
REQUIRED TOOLS 9
SUPPORT AND SERVICE 10
SOCIAL MEDIA 10

- 3 -