EKWB EK-FC TRIO RTX 2080 Ti Backplate Classic Service Manual

EK-FC TRIO RTX 2080 Ti Backplate Classic

BACKPLATE

INSTALLATION MANUAL

This product is intended for installation only by expert users. Please
consult with a qualified technician for installation. Improper installation
may result in damage to your equipment. EK Water Blocks assumes no
liability whatsoever, expressed or implied, for the use of these products,
nor their installation. The following instructions are subject to change
without notice. Please visit our web site at www.ekwb.com for updates.
Before installation of this product please read important notice, disclosure
and warranty conditions printed on the back of the box.

Before you start using this product please follow these basic guidelines:

Please carefully read the manual thoroughly before beginning
with the installation process!

Please remove your graphics card from the computer to assure
safest mounting process in order to prevent any possible
damages to your GPU and/or graphics card circuit board (PCB).

The EK fittings require only a small amount of force to screw
them firmly in place since the liquid seal is ensured by the
rubber O-ring gaskets.

The use of corrosion inhibiting coolants is always recommended
for any liquid cooling system.

Do not use pure distilled wate r! For best results EK recommends
the use of EK-CryoFuel coolants!

- 2 -

TABLE OF CONTENT

GENERAL INFORMATION 4
PREPARING YOUR GRAPHICS CARD 4
ATTACHING EK-FC Trio RTX 2080 Ti Backplate Classic TO THE GRAPHICS CARD 5
REQUIRED TOOLS 6
IMPORTANT DISCLOSURES 6
SUPPORT AND SERVICE 7
SOCIAL MEDIA 7

- 3 -