E-flite 7.2-8.4 DC Glider Fast Charger User Manual

Thank you for purchasing an E-flite™ charger.
This DC-powered 7.2-8.4V time charger will
allow you to fast charge Ni-Cd and Ni-MH
battery packs for your electric glider. When
used properly following these instructions,
this charger will provide many years of
trouble-free operation.

• Charges 6- or 7-cell 1200-2000mAh
Ni-Cd and Ni-MH packs

• 20- to 30-minute charger w/timer

• Heavy-gauge wire with large alligator clips

• Tamiya connector

This DC Fast Charger requires a 12V power
source, such as a 12V 7-amp Sealed Battery
(HAN102) or an automobile 12V battery.

• Input Leads: 6ft w/large alligator leads

• Output Leads: 1ft w/Tamiya-style connector

• Timer: 30 minutes

• Case Size: 5

3

/4" x 3" x 2"

• Charge Indicator: red LED

• Trickle-Charge Rate: 30mAh

• Charge Rate: 3.6 amps

• Do not attach the charger to an auto­mobile battery while the engine is running.

• Do not leave the charger unattended
while you are charging a battery pack.

• Continuously monitor the temperature
of the battery pack while it is being
charged. If the pack at any time becomes
very warm to the touch, disconnect the
battery immediately.

Instructions

EFLC2002 Features

Supplying Power to the Charger

EFL2002 Specifications

EFLC2002

DC Fast Charger

for Electric Gliders

Safety Tips

1. Prior to charging, make sure the battery
pack is completely discharged by running
the electric motor until it slows down.

Note: Discharge the Ni-Cd pack every
cycle. Failure to do so will decrease the
capacity and flying time of the battery.

2. For best results, let the battery pack cool
before charging. Heat can prevent a battery
from charging to full capacity and also
decreases the performance of the battery.

3. Once the pack is ready to be charged,
attach the red (positive +) alligator clip to
the red "positive" terminal of the 12V
power source.

4. Attach the black (negative-) alligator
clip to the "negative" terminal of the
12V power source.

5. Make certain that you hook up the
charger to the correct polarity of the
12V power source.

6. Use the graph provided on the back of the
charger to select the correct charge time
needed to fully charge the battery pack.
The graph will give a recommended
charging time (of a fully discharged
battery) based upon the capacity of your
battery pack.

7. Continue to monitor the battery as it is
being charged. After the battery has been
fully charged, disconnect the charger from
the battery.

If you encounter any problems with
your E-flite™ charger, contact the
Horizon Service Center at [phone].

Charging Your Battery

Service

Visit our Web site at www.horizonhobby.com

TM