Edwards Signaling Series 100SB Pathfinder Installation Guide

Installation Instructions for Catalog Series 100SB

Pathfinder

Description and OperationDescription and Operation

Description and Operation

Description and OperationDescription and Operation

Edwards catalog series 100SB Pathfinder signals are AC
operated sealed beam rotating lights. The signals are con­duit mounted and are suitable for use in either indoor or
outdoor (weatherproof) applications.

TM

Sealed Beam Rotating Lights

MaintenanceMaintenance

Maintenance

MaintenanceMaintenance

CAUTIONCAUTION

CAUTION

CAUTIONCAUTION

T o avoid injury , prior to disassembly , disconnect power from
the unit.

Lamp Replacement

Electrical SpecificationsElectrical Specifications

Electrical Specifications

Electrical SpecificationsElectrical Specifications

Cat. Number Input Power Current

100SB*-N5 110V AC 60 Hz 0.88A

120V AC 60 Hz 1.04A
125V AC 60 Hz 1.14A

*The letter in this position of the catalog number signifies the color of
the supplied dome: A - amber, B - blue, C - clear, G - green, or R - red.

InstallationInstallation

Installation

InstallationInstallation

CAUTIONSCAUTIONS

CAUTIONS

CAUTIONSCAUTIONS

Do not apply power to the unit until installation is
completed and cover is secured.

When installing indoors, the signal may be mounted with
the dome facing either directly up or down. For outdoor
installation, the signal must be installed with the dome
facing directly up.

Conduit Mounting

1. Route the 18" wiring leads from the 100SB through a
3/4" NPT conduit (not supplied) into a junction box.
See Figure 1.

1. See Figure 1. Remove the screw in the clamp ring,
remove the ring and lift off the dome.

2. Replace the appropriate lamp with a GE-4416-1 PAR
36 lamp.

3. Replace the dome and secure with the clamp ring and
screw removed in step 1.

4. Apply power and ensure unit operates properly .

Cleaning

CAUTIONCAUTION

CAUTION

CAUTIONCAUTION

Abrasive materials or cleaners must not be used to clean
the dome.

The signal's dome should be periodically cleaned to main­tain optimum light visibility. The dome may b e cleaned
with a soft cloth or sponge using a mild detergent. Dry
the dome thoroughly before replacing.

2. Connect the green ground wire to earth ground.
Connect the black wire lead to the positive (+) power
source lead and connect the white wire lead to neutral
power source lead using wire nuts (not supplied).

3. Apply power and ensure unit operates properly .

Table 1. Replacement Parts

Cat. Number Description

Replacement Domes

100SB-LA Amber
100SB-LB Blue
100SB-LC Clear
100SB-LG Green
100SB-LR Red

Replacement Lamp

GE-4416-1 PAR 36 Replacement Lamp

P/N 3100424 ISSUE 1 © 2002

PAGE 1

Dome

Clamp Ring
PVC Base

3/4" Conduit (not supplied)

Wiring (Black to positive (+),
white to neutral and green
to ground). Wire nuts not supplied.

Junction Box (not supplied)

Figure 1. Catalog Series 100SB Pathfinder

P/N 3100424 ISSUE 1 PAGE 2