EdgeStar IW400SS Owner's Manual
SAFETY PRECAUTIONS
Read all of the instructions before using this appliance. When using this appliance,
always exercise basic safety precautions, including the following:
• Do not plug this appliance into the power socket before set up is completed.
• Do not use if the power supply cord is damaged. If damaged, it must be replaced by a
qualified technician.
• Do not use this appliance with an extension cord or power strip. Please ensure that the
appliance is plugged directly into the electrical outlet.
• Do not run the power cord over carpeting or other heat insulators. Do not cover the
cord.
• Do not submerge in water.
• Do not cut or remove the third prong (the grounding prong) from the power cord.
• The cord should be secured behind the unit and should not be left exposed or dangling.
• Never pull the power cord to disconnect it from the outlet. Grasp the plug directly and
pull it from the outlet.
• Never lift or carry the unit by the power cord.
• Use extreme caution when using hot water dispenser. Do not let hot water touch
bare skin. Exercise caution and use reasonable supervision when appliance is
used near children.
• This unit is intended for indoor use only.
• For stable installation, make sure the cooler is placed on a flat, level, and solid surface.
• When positioning the Ice Maker with Water Dispenser, ensure that there is at least a 2”
clearance at the sides and at least 4” clearance at the back of the unit. This will allow for
adequate ventilation of heat from the back of the unit.
• Avoid subjecting the cooler to external heat sources or direct sunlight.
• Do not tip over the unit.
• The Ice Maker with Water Dispenser is an electrical appliance. To avoid injury or death
from electrical shock, do not operate the water dispenser with wet hands, while
standing on a wet surface, or while standing in water.
• Do not use any liquid other than water in the dispenser or to make ice.
• Always turn off the unit and unplug it when there is no water left in a bottle or when
changing a bottle. Turn it back on after a new bottle has been installed and purge
excess air from the water dispenser buttons.
• Unplug the unit before cleaning or making any repairs.
• Do not clean the unit with flammable fluids. The fumes can create a fire hazard or
explosion.
• Disconnect the unit when not in use.
• This appliance is designed for non-commercial use only.
• Performance may vary depending on operational conditions.
1
TABLE OF CONTENTS
IMPORTANT SAFETY INSTRUCTIONS……………………...….….……...…1
INTRODUCTIONS………………………………………………….…............…3
Welcome and thank you…………………………………………………….…3
For your reference……………………………………………………………...3
Need assistance………………………………………………………………...3
GETTING TO KNOW YOUR UNIT..................................................................44
Unit outline…...……………………………………………….………………....4
Control panel…………………………………………………………………….5
Main functions……………………………………………………...……..…….5
Proper Location…………………………………………………………………5
SETTING UP YOUR UNIT……………………..………………………….…...6-7
Unpack the unit……………………………………………………………….…6
Clean your unit before first using…….………………………………………7
OPERA TING YOUR UNIT………………..…………………………………….7-9
Prepare for use………………………….……………………………………….7
Hot Water Operation…………………………………………………………....8
Cold Water Operation…………………………………………………………..8
Ice-making Operation………………….……………………………………….8
CCLLEEAANNIINNGG AANNDD MMAAIINNTTAAIINNIINNGG YYOOUURR UUNNIIT
TTRROOUUBBLLEESSHHOOOOTTIINNGG GGUUIIDDE
E…………...………..……………………….12-14
PPRROODDUUCCTT SSPPEECCIIFFIICCAATTIIOONNSS…………………………………
LIMITED WARRANTY………………………………..……………………..16-17
T …..….….……………………10
………....……………………………………....……..……....1155
2
Welcome and Thank You
Welcome and thank you for purchasing this EdgeStar IW400SS Ice Maker with Water
Dispenser. We are glad you choose us and we take pride in knowing that, like our products,
our customer service will be just as dependable. Once you complete the easy unit set up by
following this manual, your Ice Maker with water dispenser will provide you years of great
service.
Please save the original product packaging in case you need to safely transport this
appliance in the future.
For Your Reference…
Please write down the model and serial number here, as they are needed to obtain
service for your unit. The two numbers are on the label located on the back of your
unit. You may also want to staple your receipt to this manual. This will provide you
with a quick reference as these numbers will need to be obtained for possible service
under your warranty.
Model Number ______________
Serial Number _______________
Need Assistance?
To better serve you, we ask that you do the following before contacting our customer
service…
• Read this manual: it contains instructions to help you use and maintain your
appliance properly.
• If you received a damaged appliance: please immediately contact the dealer
that sold you the appliance.
• Read the troubleshooting section: in order to save you time and money we ask
you to check this section before calling customer service. This section will help you
solve common problems that might occur. If you do require service, our friendly and
efficient customer service representatives are available online via email at
service@edgestar.com or by telephone at 1-866-319-5473.
3
GETTING TO KNOW YOUR UNIT
Unit Outline
Oper at i on Panel
Ho t Wat er Faucet
Room Te mp Wat er Faucet
Co l d Wat er Faucet
Dr i p Wat er Tr ay
Ice Get t i ng
Ent r ance Door
Smart Device for
Water Bottl e
Top Cover
Handl e
Po we r Co r d
Dr ai n cap f or
hot t ank
Dr ai n cap f or
I ce di spenser
Co mpressor, condenser ,
and f an motor inside.
Locat e on t he base
boar d.
Ice Get t i ng
Ent r ance
Door ( opened)
Ice-maki ng Box
I ce and wat er
separ at or
I ce St or i ng Pl at e
( Can be t aken out
f or cl eani ng. )
Ho t Wat er Faucet wi t h
Chi l dr en Saf t y Guar d
1
2
Oper at i on :
St ep 1: Tur n t he shaf t of chi l dr en
saf t y guar d count er - cl ockwi sel y.
Step 2: Push the turned shaft
i nsi de t owards.
4
Control panel
Ho t Wat er I ndi cat or
Power Indicator
Ho t Wat er But t on
Co l d Wat er I ndi cat or
POWER
Co l d Wat er But t on
HOT
COLD
ICE
Ice-maker Button
Ice-Maker I ndi cat or
War ni ng I ndi cat or
WARN
Main functions
● Hot Water Dispensing
● Cold Water Dispensing
● Room Temperature Water Dispensing
● Ice-making
Proper Location
Position your Ice Maker with water dispenser in a location where there is proper air
Circulation and electrical connections.
• Keep the unit away from heat and direct sunlight if possible.
• This unit should not be exposed to rain.
• This unit should not be placed in a built-in or recessed area. It is designed to be
freestanding.
• The normal operation of the water dispenser depends on heat radiation from the
condenser. For the initial use, remove all packaging and allow at least 6” of room
around the freezer.
• The room temperature should not exceed 97F/36C
5
SETTING UP YOUR UNIT
UNPACKING THE UNIT
1. When removing the package, do not turn the unit upside down, or lay it on its side.
a. Remove the strapping
b. Open the cartoon box.
c. Remove the Styrofoam packing from the box.
d. Pull the unit straight up from the box.
e. Remove the plastic bag.
Note: The refrigeration compressor has very sensitive mounts
inside of its welded shell in order to provide quiet running.
Improper handling may damage the compressor.
2. Clean the interior surface with a little bit of lukewarm
water and a soft cloth (See “Cleaning Your Unit Before U
section).
3. The appliance must be positioned so that the plug is
accessible.
4. Fasten the drain cap tightly at the back of the unit before
you start to run the unit. During the shipping process, it may
have loosened.
Note: Do not plug the power cord into the power socket yet!
Read the instructions first.
se”
This unit is for indoor use only.
Room temperature should not exceed 97°F
6
Loading...