Edge Lighting Dual Feed Surface Mount Magnetic Transformer User Manual

© 2013 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

M2T-2X150-12-_

904-M2T-2X150-12-06

Installation Instructions for Monorail 2 Circuit 2 X 150

Mount Magnetic Transformer

120 Volt Input to 12 Volt Single

Watt Surface

Feed Output

SAVE THESE INSTRUCTIONS!

GENERAL INFORMATION IMPORTANT SAFETY INSTRUCTIONS

- RISK OF FIRE: This product must be installed by a
qualified electrician. Turn the power to the electrical box off
during installation. Read the "Important Safety Instructions"
before installation.

- This product is suitable only for indoor dry locations and
approved for the use at any height above the finished floor.

- This product contains a magnetic transformer with a built-in
dimming coil.

- Do not install this lighting system in a damp or wet
location.

- Do not conceal or extend bus bar conductor through
building wall.

- To reduce the risk of fire and burns, do not install this
lighting system where the insulated open bus bar
conductors can be shorted or contact any conductive
materials.

- This product may be dimmed only with a low voltage
magnetic dimmer. Using a dimmer other than specified may
work initially, but will eventually cause transformer failure
and void the warranty. The dimmer must be derated as
indicated by the dimmer manufacturer.

- A typical installation is shown. Specific installation must be
in accordance with the local electrical codes.

- Load each circuit of the surface mount transformer to
MAXIMUM 150 Watt.

- To reduce the risk of the system overheating and possibly
causing a fire, make sure all the connections are tight.

- Do not install fixture assemblies closer than six inches, or
as specified in the fixture installation instructions, to
curtains or similarly combustible materials.

- Turn the electrical power off before modifying the lighting
system in any way.

- The fixtures used with the Edge Lighting systems must be
identified for use with the corresponding Edge Lighting
systems.

- Minimum volume of the electrical box must be 6 cubic
inches (98 cubic centimeters).

- The system is "ETL" listed for USA and Canada only when
all the products used are supplied by Edge Lighting.

1

Install the Surface Mount Transformer

A

1

2: Unhook the transformer cover from the set screw and

remove it from the transformer housing.

CROSSBAR

C

ASSEMBLY

M4 BUTTON
HEAD SCREW

1

3

2MM ALLEN WRENCH

1

COVER

1: Loosen and remove the five M4 button head screws around
the transformer cover with the provided 2mm Allen wrench.

SET SCREW

B

HOUSING

2

COVER

3: Remove the inside nut and washer to remove the crossbar
assembly. DO NOT DISASSEMBLE THE CROSSBAR

ASSEMBLY.

INSIDE NUT

The 120 volt transformer wires must be connected to the

NOTE:

same phase of 120 volt power wires.

4: Connect one set of provided white and black extension wires
to the neutral and hot power wires coming from a switch
respectively with the wire nuts provided.

5: Connect the other set of provided white and brown extension
wires to the neutral and hot power wires coming from the
other switch respectively with the wire nuts provided.

6: Feed the extension wires through the crossbar assembly
nipple.

7: Place all wires and wire nut connections inside the electrical
box.

8: Mount the crossbar assembly to the electrical box with the
two provided #8-32 screws.

9: Make sure the crossbar assembly is grounded in accordance
with local electrical codes.

WASHER

D

4

#8-32 SCREW

EXTENSION WIRES

9

7

8

6

CROSSBAR ASSEMBLY
NIPPLE

2