Eden WTDI User Manual

WTDI ʻWORLD TOURʻ DIRECT BOX PREAMP PEDAL OPERATION MANUAL

Congratulations on your purchase of the new EDEN WTDI.
Performance and portability are the key features in this palm­sized package of “World Tour” tone!

NEVER COMPROMISE.

1. 1/4” instrument input - Plug your instrument into this.

2. Input Gain Level - Regulates the gain stage of the preamplifier and controls the
amount of signal available to the unit.

3. Bass EQ level - 15dB of boost or cut at approximately 30Hz.

4. Bass Boost - Dynamic Bass boost along Fletcher-Munson Curve

5. Midrange EQ - Boost or cut middle frequency (as selected by mid-shift)

6. Mid Shift - flip between 550Hz and 2.2KHz as adjustable midrange frequency

7. Treble -15db of boost or cut at approximately 5KHz

8. Enhance - ʻakaʼ the “Magic Knob” This complex control simultaneously boosts the
very low bass, upper middle, and high frequencies.

9. Compressor - Smooths out peaks in signal while boosting low level information.
Amount of compression controlled by knob and fed by input gain level.

10. Master Level Output - Adjusts overall output and loudness to (11) & (13)

11. XLR Direct output - Connect to Balanced PA or recording input.

12. Ground Lift for XLR output - lifts ground to match with other gear.

13. 1/4” Instrument level output - Connects to amplifier input, power amp input or
unbalanced audio input of any device.

14. Power Supply connection - Plug in included 12-18Volt PSU - Center Pin Positive

15. Bypass footswitch - engages or disables WDTI signal function - (signal will pass un-

affected in bypass mode.)