Eden W10, W20, W30, W40, W50 Installation, Operation And Maintenance Manual
...
10-120
RANGE
INSTALLATION, OPERATION AND
MAINTENANCE GUIDE
CENTRIFUGAL
3
I N S T A L L A T I O N , U S E A N D M A I N T E N A N C E M A N U A L
RANGE
WIND
3
1.0 INTRODUCTION 3
2.0 RECOMMENDATIONS 3
FIRST PART: FOR THE INSTALLER
3.0 TRANSPORTATION, RECEIVING, HANDLING 3
3.1
Safety rules
3
4.0 APPLIANCE DESCRIPTION 4
4.1
General technical data
4
4.2
Main parts
4
5.0 INSTALLATION 5
5.1
Recommendations for installation
5
5.2
Fan coil installation
5
6.0 WATER CONNECTIONS 6
6.1
Connection to the water mains
6
6.1
Condensate water drainage
6
7.0 ELECTRICAL CONNECTIONS 6
7.1
Recommendations
6
7.2
Connections to the terminal block: housing w ithout control panel
6
7.3
Connections to the terminal block: housing w ith control pane l
6
7.4
Changing the motor speeds of rotation
7
8.0 FAN COIL TESTING 7
9.0 TURNING THE COIL 7
SECOND PART: FOR THE USER
10.0 USING THE APPLIANCE 8
10.1
Warnings
8
10.2
Using the control panel
8
11.0 CLEANING THE APPLIANCE 9
10.1
Cleaning the air filter
9
10.2
Cleaning the housing and the control panel
9
12.0 TROUBLESHOOTING 10
13.0 DISMANTLING THE APPLIANCE 10
14.0 WARRANTY 10
DECLARATION OF CONFORMITY 11
1.0 INTRODUCTION
This installation, operation and maintenance booklet should always
accompany the fan coil for ready consultation by the installer or user if
necessary. The appliance should be installed in compliance with the
regulations in force in each country and according to the manufacturer's
or qualified installer's instructions. The manufacturer cannot be held liable
for any damage to property or injury to persons and animals caused by
incorrect installation of the appliance. Only qualified persons should install
the appliance and connect it to the mains electricity supply.
Before carrying out any work on the appliance, ensure that it is disconnected
from the electricity supply. Read this instruction booklet before installing
the appliance.
2.0 RECOMMENDATIONS
The appliance is easy to use, but it is important to read this guide
completely before using for the first time. This will help you to:
- use the appliance in all safety;
- obtain best performance;
- avoid errors;
- respect the environment:
- Do not allow children or unassisted handicapped persons to use
the appliance.
- Do not touch the appliance with wet parts of the body or if barefoot.
- Do not tug, pull or twist electrical cables attached to the appliance,
even when disconnected from the electricity supply.
- Do not open the flaps giving access to the internal parts of the
appliance without having first put the system on-off switch to "off".
- Do not introduce sharp pointed objects through the air intake and
outlet grilles.
- Do not leave packing material (cardboard, staples, plastic bags,
etc.) within reach of children since they could be a source of
danger. Dispose of correctly.
- Do not sit or climb on the appliance or rest any type of object on
it.
- Do not spray or throw water directly on the appliance.
!
3.1 SAFETY RULES
- Secure packs during transportation..
- Do not expose to the elements.
- Do not tread on packs.
- Protect hands with work gloves when dismantling the appliance.
- Work in PAIRS if the appliance weighs more than 25 kg.
Fig. 01
3.0 TRANSPORTATION, RECEIVING, HANDLING
The appliance is dispatched enclosed in special protective packaging,
which should be kept intact until the appliance is positioned in the
final place of installation.
The appliance should be handled with extreme care, always keeping
it in its original packaging.
One pallet may hold 11 fan coils model WIND 10-60 (9 in vertical +
2 in horizontal) or 9 fan coils model WIND 70-90 (9 in vertical).
To take the appliance out of the packaging, proceed as follows (fig.
1):
1. Turn the fan coil box upside down and open the bottom.
2. Remove the polystyrene filling and keep it.
3. Keeping the bottom of the box open, turn the pack 180°, taking
care that the contents are firmly held before resting it gently on the
ground. Lift off the packaging from the appliance.
1
2
- Do not use the appliance in places with suspended dust/powder
or in potentially explosive atmospheres, in very damp environments
or in the presence of oil in suspension or in particularly aggressive
atmospheres.
- Do not cover the appliance with objects or drapes that even partially
obstruct the air flow.
- The appliance works by electricity at mains voltage (230 Vac, 50
Hz). Always bear in mind that mains voltage is potentially dangerous
and any appliance connected to it should be used with caution.
- Before carrying out any work on the appliance, disconnect it from
the electricity supply (by pulling out the plug from the mains socket
or isolating the supply line by putting the on-off switch to off).
- If the appliance is not to be used for long periods, make sure that
the controls are in the position 0 (off). If the appliance is not going
to be used in winter when temperatures are near to freezing, drain
the system and ensure that the appliance heat exchanger has no
water in it in order to prevent the formation of ice and consequent
breakage.
To make the appliance inoperable, disconnect it totally from the
electricity supply.
It is unsafe to alter or try to alter the characteristics of this product.
Any tampering or alteration renders the warranty null and void.
In the event of malfunction or failure, do not try to repair the
appliance yourself; contact a qualified technician. Repairs carried
out by unqualified persons could cause damage or accidents.
Always keep the appliance clean. In particular clean the air filter
periodically (at least once a month).
FAILURE TO COMPLY WITH THE ASSEMBLY INSTRUCTIONS
GIVEN IN THIS GUIDE RELIEVES EDEN S.R.L. OF ALL AND ANY
LIABILITY. INCORRECT INSTALLATION COULD CAUSE
MALFUNCTIONING OR FAILURE OF THE APPLIANCE. IT COULD
ALSO REPRESENT A HAZARD FOR THE USER.
3
2
C E NT R IF UG A L FA N CO I L U N I T
R A N G E
WIND
I N S T A L L A T I O N , U S E A N D M A I N T E N A N C E M A N U A L
4
4.0 APPLIANCE DESCRIPTION
Fig. 02
M ode ls W I ND 70 ÷9 0M od el s WIN D10 ÷60
200
without cabinet
220
225
200
220
225with cabinet
L
25
30
M
D
C180 110
257
with cabinet
M od el s WIN D100 ÷ 120 *
Ø 20
234
Ø 20
Ø 20
GENERAL DIMENSION
Tab. 1Electrical supply 230V/1/50 Hz
Fig. 03
15
13
15
13
2
5
6
4
3
1
78910
11
12
14
4.2 MAIN PARTS
4.1 GENERAL TECHNICAL DATAS
MODELS W10 W20 W30 W40 W50 W60 W70 W80 W90 W100 W110 W120
Fans No. 1 1 2 2 2 2 2 2 2 3 3 3
Row No. 3 3 3 3 3 3 3 3 3 3 3 3
Fittings Ø 3/4” 3/4” 3/4” 3/4” 3/4” 3/4” 3/4” 3/4” 3/4” 3/4” 3/4” 3/4”
Row No. 1 1 1 1 1 1 1 1 1 1 1 1
Fittings Ø 1/2” 1/2” 1/2” 1/2” 1/2” 1/2” 1/2” 1/2” 1/2” 1/2” 1/2” 1/2”
Condensate drain fitting Ø mm 20 20 20 20 20 20 20 20 20 20 20 20
High mm 480 480 480 480 480 480 585 585 585 602 602 602
Lenght mm 660 860 1.060 1.060 1.260 1.260 1.260 1.460 1.460 1.660 1.960 1.960
Depth mm 220 220 220 220 220 220 220 220 220 256 256 256
(M )
mm 420 620 820 820 1.020 1.020 1.020 1.220 1.220 1.380 1.680 1.680
(C)
mm 370 570 770 770 970 970 970 1.170 1.170 1.330 1.630 1.630
(D)
mm 395 595 795 795 995 995 995 1.195 1.195 1.356 1.656 1.656
Net weight kg 14 17 22 23 27 28 30 35 36 46 55 57
Auxiliary coil
(H)
(L)
(S)
Standard coil
LEGENDA
1 Air valve
2 Exchange coil
3 Minimum water temp. sensor
4 Control panel
5 Condensate drain pan
6 Room thermostat sensor
7 Air filter
8 Electric motor
9 Centrifugal fan
10 Condensate drain
11 Wall-mounting slots
12 Water connections
13 Coil fixing screws
14 Load-bearing structura
15 knockouts
3/4" G
1/2" G
1/2" G
3/4"G
1/2" G
3/4"G
* Dimension referred to the units with left side water connections.
Loading...