Page 1
• Please study these instructions carefully before installing your
THROTTLE KICKER BRACKET
Catalog #1997
for Edelbrock Performer Series Q-Jet
Carburetor #1903
Performer Q-Jet carburetor #1903 viewed from left
THROTTLE KICKER BRACKET
Catalog #1997
for Edelbrock Performer Series Q-Jet
Carburetor #1903
Performer Q-Jet carburetor #1903 viewed from left
new Throttle Kicker kit. If you have any questions or problems, do
not hesitate to contact our Technical Hotline at: (800) 416-
8628 from 7:00 am to 5:00 pm, Monday through Friday, Pacific
Standard Time or e-mail us at: edelbrock@edelbrock.com.
• APPLICATIONS
Edelbrock Throttle Kicker Bracket #1997 is an adapter to connect a
factory vacuum operated throttle kicker to Edelbrock Q-Jet
carburetor #1903. This applies to 1980-1985 350, 400 and 454
c.i.d. engines in 3/4 and one-ton trucks with heavy duty chassis
and hot air choke. If original equipment carburetor has factory
cruise control, use the original stud and nut instead of included
hardware. Figure 1 shows typical installation on Q-Jet carburetor
#1903.
• INSTALLATION
Install bracket over carburetor throttle arm stud as shown in
Figure 1. Use bolt, nut and washer supplied to attach.
©2002 Edelbrock Corporation
Brochure No. 63-0123
Rev. 7/02
Figure 1
Throttle Kicker Bracket installed on Edelbrock
(driver's) side.
• Please study these instructions carefully before installing your
new Throttle Kicker kit. If you have any questions or problems, do
not hesitate to contact our Technical Hotline at: (800) 416-
8628 from 7:00 am to 5:00 pm, Monday through Friday, Pacific
Standard Time or e-mail us at: edelbrock@edelbrock.com.
• APPLICATIONS
Edelbrock Throttle Kicker Bracket #1997 is an adapter to connect a
factory vacuum operated throttle kicker to Edelbrock Q-Jet
carburetor #1903. This applies to 1980-1985 350, 400 and 454
c.i.d. engines in 3/4 and one-ton trucks with heavy duty chassis
and hot air choke. If original equipment carburetor has factory
cruise control, use the original stud and nut instead of included
hardware. Figure 1 shows typical installation on Q-Jet carburetor
#1903.
• INSTALLATION
Install bracket over carburetor throttle arm stud as shown in
Figure 1. Use bolt, nut and washer supplied to attach.
©2002 Edelbrock Corporation
Brochure No. 63-0123
Rev. 7/02
Figure 1
Throttle Kicker Bracket installed on Edelbrock
(driver's) side.
Loading...