Edelbrock 15016 User Manual

TURBOCHARGER TO OUTLET ELBOW GASKET
(For Turbocharger Kit #1500, 1501, 1502, 1503, 1504)
Catalog #15016
INSTALLATION INSTRUCTIONS
DESCRIPTION: Stainless steel gasket used to seal the turbocharger turbine outlet. It can also be used with any Garrett T25 or T28
Turbocharger.
INSTALLATION
1. When attaching the exhaust outlet elbow to the turbocharger turbine outlet, tighten the nuts in a criss-cross pattern. This will evenly compress the gasket. Tighten the nuts in a few increments until the gasket is fully compressed.
2. Torque the 8mm x 1.25 nuts to 190 inch/lbs. (approximately 16 ft/lbs).
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503
Tech Line: 1-800-416-8628 • E-Mail: Edelbrock@Edelbrock.com
Catalog #15016 Rev. 5/05
©2005 Edelbrock Corporation
Brochure #63-0396
TURBOCHARGER TO OUTLET ELBOW GASKET
(For Turbocharger Kit #1500, 1501, 1502, 1503, 1504)
Catalog #15016
INSTALLATION INSTRUCTIONS
DESCRIPTION: Stainless steel gasket used to seal the turbocharger turbine outlet. It can also be used with any Garrett T25 or T28
Turbocharger.
INSTALLATION
1. When attaching the exhaust outlet elbow to the turbocharger turbine outlet, tighten the nuts in a criss-cross pattern. This will evenly compress the gasket. Tighten the nuts in a few increments until the gasket is fully compressed.
2. Torque the 8mm x 1.25 nuts to 190 inch/lbs. (approximately 16 ft/lbs).
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503
Tech Line: 1-800-416-8628 • E-Mail: Edelbrock@Edelbrock.com
Catalog #15016 Rev. 5/05
©2005 Edelbrock Corporation
Brochure #63-0396
Loading...