Edelbrock 15013 User Manual

TURBOCHARGER TURBINE OUTLET STUD KIT

For Turbine Outlet to Outlet Elbow

Catalog #15013

INSTALLATION INSTRUCTIONS

Description: Contains the necessary hardware to mount the outlet elbow to the turbine outlet. The hardware is constructed of high-

quality stainless steel and can be used with any Garrett T25 or T28 Turbocharger.

• KIT CONTENTS:

Qty. Description

❑ 5 Stud, 8mm x 1.25 x 1.75” long ❑ 5 Nut, 8mm x 1.25 ❑ 5 Washer, 8mm

• INSTALLATION:

1. Hand tighten the 1.75” long studs into the turbine outlet, with the longer threads towards the turbine outlet (See Fig. 1).

2. When attaching the turbocharger to the exhaust manifold, and the turbo outlet elbow to the turbocharger, use an 8mm washer under each nut, and hand tighten the 8mm x 1.25 nuts onto the studs.

3. Torque the 8mm x 1.25 nuts to 190 inch/lbs. (approximately 16 ft/lbs).

Towards Turbine

Outlet

Edelbrock Corporation

2700 California St. • Torrance • CA • 90503

Tech Line: 1-800-416-8628

E-Mail: Edelbrock@Edelbrock.com

1.75”

Towards Exhaust

Elbow

Fig. 1

Catalog #15013 Rev. 5/05 - RS/mc

Brochure #63-0393