Edelbrock 15003 User Manual

Rev. 1/04 - RS/mc

Brochure #63-0243

TURBOCHARGER GASKET KIT

(For Turbocharger Kit #1500)

(For Turbocharger Kit #1500)

Catalog #15003

INSTALLATION INSTRUCTIONS

PLEASE study these instructions carefully before installing your new Edelbrock Turbocharger Gasket Kit. If you have any

questions or problems, do not hesitate to contact our Technical Hotline at: 1-800-416-8628, from 7am-5pm, Monday­Friday, Pacific Standard Time or via e-mail at: [e-mail]. Please fill out and mail your warranty card.

• Description: This gasket kit contains the stainless
steel gaskets that are used to seal the turbocharger
turbine inlet and outlet. They can also be used with any
Garrett T25 or T28 Turbocharger.

Installation Notes

1. When attaching the turbocharger to exhaust manifold, tighten the nuts in a criss-cross pattern. This will evenly compress
the gasket. Tighten the nuts in a few increments until the gasket is fully compressed.

2. Repeat on the exhaust outlet elbow.

3. Torque the 8mm x 1.25 nuts to 190 inch/lbs. (approximately 16 ft/lbs).

Edelbrock Corporation, 2700 California St., Torrance, CA 90503

Tech Line: 1-800-416-8628; Office: [phone]

E-Mail: [e-mail]

©2004 Edelbrock Corporation
Rev. 1/04 - RS/mc

• Kit Contents:
Qty. Description

❑ 1 Gasket, Turbocharger to Exhaust Manifold
❑ 1 Gasket, Turbocharger to Outlet Elbow

Catalog #15003

Brochure #63-0243

TURBOCHARGER GASKET KIT

Catalog #15003

INSTALLATION INSTRUCTIONS

PLEASE study these instructions carefully before installing your new Edelbrock Turbocharger Gasket Kit. If you have any

questions or problems, do not hesitate to contact our Technical Hotline at: 1-800-416-8628, from 7am-5pm, Monday­Friday, Pacific Standard Time or via e-mail at: [e-mail]. Please fill out and mail your warranty card.

• Description: This gasket kit contains the stainless
steel gaskets that are used to seal the turbocharger
turbine inlet and outlet. They can also be used with any
Garrett T25 or T28 Turbocharger.

Installation Notes

1. When attaching the turbocharger to exhaust manifold, tighten the nuts in a criss-cross pattern. This will evenly compress
the gasket. Tighten the nuts in a few increments until the gasket is fully compressed.

2. Repeat on the exhaust outlet elbow.

3. Torque the 8mm x 1.25 nuts to 190 inch/lbs. (approximately 16 ft/lbs).

Edelbrock Corporation, 2700 California St., Torrance, CA 90503

Tech Line: 1-800-416-8628; Office: [phone]

E-Mail: [e-mail]

©2004 Edelbrock Corporation

• Kit Contents:
Qty. Description

❑ 1 Gasket, Turbocharger to Exhaust Manifold
❑1 Gasket, Turbocharger to Outlet Elbow

Catalog #15003