Page 1
email - support@aampglobal.com (US)
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - technical.eu@aampglobal.com (Europe)
Installation Guide
1
Installation Guide
Factory Connect Camera System:
Toyota
All Models equipped with 6.1” Screen
FC-TOYO
1 2
3 4
5 6
Remove radio / multi-media assembly.
Unplug factory 16 pin plug and plug into female
end of T-Harness. Plug male end of harness into
rear of radio. Connect camera RCA cable to
T-Harness.
A. Connect camera Red wire to suitable
ACC or IGN +12V. Ground camera Black
wire.
Use foam gasket to determine camera
mounting location. Drill a 19mm hole, mount
camera and secure with nut.
Connect the camera cable to the camera.
Program optional Parking Lines and/or
Image Flip.
Check installation by putting vehicle in reverse to
make sure image is correct. Reassemble all parts
of the vehicle to complete installation.
EXISTING
PLUG
16 PIN
CONNECTOR
Camera Cable
GND
+12V ACC/IGN
B. Route camera cable to rear of vehicle.
Green Wire (Parking Lines)
White Wire (Image Flip)
NOTES:
Camera must be connected to ACC
or IGN not reverse trigger.
Page 2
email - support@aampglobal.com (US)
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - technical.eu@aampglobal.com (Europe)
Installation Guide
2
15500 Lightwave Drive, Suite 202
Clearwater, Florida 33760
EchoMaster is a Power Brand of AAMP Global
Woolmer Way, Bordon, Hampshire,
GU35 9QE, United Kingdom
EchoMaster.com
ATTENTION:
On some 2013 model year Toyotas, reverse trigger is not present at radio. You must add a pin to the 28 pin plug located
next to the 16 pin plug provided by EchoMaster.
The pin will go in Pin# 2 located on the top row second pin from right (see diagram provided). Insert pin provided and
connect to positive 12 volt reverse.
Factory Connect Camera System:
Toyota
For Models Equipped with 6.1” Screen
Loading...