Echo Bear Cat 76371-00 User Manual

Instructions

RH WHEEL,
PH 76368-00

LH WHEEL,
PN 76369-00

SUBJECT: WHEELED VACUUM

REPLACEMENT WHEELS

(KITS 76371-00 AND 76372-00)

FITS MODELS:

ALL WHEELED VACS

Before inspecting or servicing any part of this machine,
shut off power source and make sure all moving parts
have come to a complete stop.

WARNING

REPLACING REAR WhEELS ON SELF-PROPELLED MODEL (KIT # 76371-00)

(FOR PUSH MODEL INSTRUCTIONS, SEE THE OTHER SIDE)

Start with the side that contains the drive sprocket (left side). Remove the existing wheel by removing the pushnut 1.
and pulling the wheel off the axle shaft.

Install the LH wheel, spacer, and pushnut onto the left axle shaft. NOTE:The right and left wheels can be distinguished 2.
by looking at the arrow imprinted near the center of the wheel. The wheel should be installed so that the arrow is
pointing the way the wheel will turn when the vacuum is pushed forward.

Remove the right side wheel and the pushnut. Slide the new wheel and spacer onto the axle shaft and secure it 3.
with the pushnut provided.

Instruction Sheet

PN 76370-00

Rev. 092209

REPLACING FRONT WhEELS ON SELF-PROPELLED MODEL (KIT # 76372-00)

WHEEL,
PN 31196-00

PUSHNUT

WHEEL,
PN 31196-00

PUSHNUT

REPLACING ALL WhEELS ON PUSh MODEL (KIT # 76372-00)

Remove the pushnut from one of the front wheels. Remove the wheel and washers. Save the washers to reuse later.1.

Slide a new washer on the axle, the new wheel (PN 31196-00), and two washers.2.

Due to differences in machines, you may need to adjust the number of washers needed to provide a good fit for the 3.
pushnut. Approximately 5/16" of the axle should be visible after the last washer.

Secure the wheel with a new pushnut.4.

Repeat for the other front wheel.5.

PUSh MODELS ONLY:6. Remove the pushnut and slide one of the rear wheels off the long shaft axle.

Slide the new wheel (PN 31196-00) on the shaft axle, adusting with necessary washers, and securing with the pushnut. 7.
Repeat for the other rear wheel.

NUMBER

15097 WASHER, 1/2 SAE FLAT 6

15399 PUSHNUT, 1/2 IN 3

31196-00

PART

76372-00, VACUUM WhEELS KIT

PUSh MODEL AND SELF PROPELLED

DESCRIPTION qTY

WHEEL ASSEMBLY, 410/350-4 W/
1-2 INCH BEARING

Phone: [phone] • Toll Free: 800.247.7335 • Fax: [phone]

E-mail: [e-mail] • [e-mail]

76371-00, VACUUM DRIVE WhEELS KIT

SELF-PROPELLED MODEL REAR WhEELS

PART

NUMBER

15399 PUSHNUT, 1/2 IN 3

SPACER, 1-1/8 OD X 1-1/8 X 5/8

76367-00

2

76368-00

76369-00

ID 2

WELDMENT, RH VACUUM
WHEEL 1

WELDMENT, LH VACUUM
WHEEL 1

www.bearcatproducts.com

DESCRIPTION qTY

EChO BEAR CAT

237 NW 12th Street, West Fargo, ND 58078-0849