Model: ECHO-1
1-Button 2-way Upgrade Kit
July 17, 2013
Operation & Installation Guide
Controller Overview
Your system operations are dependant on the design of the
system being used with the ECHO kit. Please refer to the system’s operation guide for details on each function. The controller
button will perform the same operations as your original transmit-
ter’s button with added 2-way con rmation.
SYSTEM OPERATIONS
2-way controller part number: 115-07
Call your dealer or visit www.caralarm.com to order
replacement transmitters.
“Start/unlock” button.
It’s backlit with a green
light to give 2-way
visual con rmations
115-07 Battery type:
CR2032 (Qty: 1)
When remote start is activated, the controller will respond with two green light fl ashes and play the “remote
start” tone (unless in mute mode). After the engine is running, the green light will fl ash once every 2 seconds. When
remote start is turned off in any way, the controller will play the “remote stop” tone (unless in mute mode) and the
green light will no longer fl ash.
REMOTE START
Controller Options
The controller responds with two green light fl ashes and two beeps (unless in mute mode).
UNLOCK
Insert the battery while NOT pressing the controller button. The LED (light) above the button will NOT fl ash, indicat-
ing that the controller is in “Audible” mode.
AUDIBLE MODE (DEFAULT)
Press and hold the controller button while inserting the battery. The LED (light) above the button will fl ash once,
indicating that the controller is in “Mute” mode.
MUTE MODE
Controller 2-way Functions
The ECHO-1 communicates with a window-mounted base unit which is plugged directly into the host
system’s module. The window-mount antenna should be mounted directly to the interior glass by
utilizing the attached adhesive pad (clean the glass before adhering) for the best performance. The
receiver/transmitter also contains alternative Status Lights and a Valet Switch. These may be used, or
the original items may be retained.
Step 1
Locate &
Remove the
security system’s
antenna port.
Step 3 Program the Echo controller and the
original 1-way transmitters into the system
(see the system’s operation guide for instructions).
Echo Base
Transmitter/
Receiver Unit
Step 2 Plug in and route the Echo
transmitter/receiver unit wiring harness.
NOTE: Some systems’ existing harness
can be used.
Host Omega Security
System Control
Module
LED and
Valet Switch
plugs.
V
(congurations vary)
Installing & Programming The ECHO System
( ( (ECHO
This device complies with FCC Rules part 15. Operation is subject to the following
two conditions, (1) This device may not cause harmful interference and, (2) This
device must accept any interference that may be received, including interference
that may cause undesired operation.
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modi cations to this equipment. Such modi cations could void the
user’s authority to operate the equipment.
www.caralarm.com | 800.554.4053
www.facebook.com/omegard
Loading...