Eberspacher EasyStart R User Manual
EasyStart R
+
Operating instructions.
Comfort radio remote control
with integrated timer
for parking heaters and more.
22 1000 32 80 06
03.2009
Contents
Introduction
• Please read first...................................................................................................... 3
• Purpose ................................................................................................................. 3
• Safety information ..................................................................................................3
• Statutory regulations ..............................................................................................3
• General information ................................................................................................4
Overview
• Mobile unit of the radio remote control ...................................................................5
• Displays .................................................................................................................6
Operation and Adjustment
• Basic operation and adjustment rules ..................................................................... 7
• Activate mobile unit ................................................................................................ 8
Set weekday, time and operating time ............................................................... 9
Switch on heater .............................................................................................. 10
Switch off heater .............................................................................................. 11
Switch on ventilation ........................................................................................ 12
Switch off ventilation / General information on ”ventilate“ mode ........................ 13
Switch on add-on unit ...................................................................................... 14
Switch off add-on unit / General information on the add-on unit ....................... 15
General information on programming the preset time ....................................... 16
Program preset times .............................................................................. 17 – 18
Delete preset times .......................................................................................... 19
Heizstufe einstellen – bei Wasserheizgeräten ....................................................20
Heizstufe einstellen – bei Wasserheizgeräten ....................................................21
Maintenance
• Battery charge status ........................................................................................... 22
• Replace battery .................................................................................................... 22
What to do if …?
• Displays ....................................................................................................... 23 – 25
Service
• Hotline ................................................................................................................. 26
2
Introduction
Please read rst
Before you start to set and use the
radio remote control, please ensure you
carefully read through these operating
instructions.
These operating instructions contain
important information, which you require
to set and use the radio remote control.
Please store these operating instructions
in a safe place so you can refer to it at a
later date.
Safety information
Important! Danger!
– Only the battery cover of the mobile unit
may be opened.
– The battery and battery cover must be
kept out of reach of children – swallowed small parts.
– Before washing clothing, remove the
mobile unit from pocket.
– Protect the mobile unit from adverse
effects (impacts, extreme temperatures,
moisture, rain, liquids).
– The mobile unit and heater must be
switched off when refuelling.
– Dispose of the battery and mobile part
according to the statutory regulations.
– Improper use and use outside the
specified area of use cancels all liability
and warranty.
– Only use the recommended battery and
original spare parts.
– All information and notes, in particular
the safety information in the heater‘s
technical description must be observed
at all times!
Statutory regulations
Return / disposal of electrical
and electronic equipment in accordance with Art 4 Paragraph 1
Alt Fz-VO (End-of-Life Vehicles
Regulations)
As a part of the vehicle, when the vehicle
is handed into a recognised waste collection body, a recognised returns body or
a recognised dismantling firm, the radio
remote control must be placed in the
vehicle for return in accordance with Art 4
Paragraph 1 Alt Fz-VO.
Purpose
The bidirectional radio remote control
EasyStart R+ (mobile unit in conjunction
with stationary unit) is used for remote
controlled switching on / off and presetting the switching on time, operating time
and mode of the heater and/or add-on
unit installed in the vehicle.
Please note!
Improper use and use outside the specified area of use cancels all liability and
warranty.
3
Introduction
General information
The mobile unit of the radio remote control has a simple control structure.
With only 4 keys, it is possible to set all
functions, change them if necessary and
program the preset times.
The switching pulses of the mobile unit
have an outdoor range (direct visual
contact) of up to 1000 metres. External
interference, local conditions and dense
building development in the surrounding
area shorten the range.
displays can appear which are described
in the chapter “What to do if …?” from
page 23.
If you and the mobile unit are outside the
range you do not have to do without the
heater.
The preset mode is then available as an
alternative.
If a vehicle was disconnected from the
power supply (battery disconnected) and
the power supply is reinstated, the time
appears when the mobile unit is activated.
This must then be adjusted. See description on page 9 “Set weekday, time and
operating time”.
Operation of the mobile unit is described
in detail from page 7.
The mobile unit
should always be
pointed towards
the vehicle when
activated or for
data transmission.
Depending on
use and ambient
effects however,
4
Overview
Mobile unit of the radio remote
control
The mobile unit of the radio remote con-
trol can be used to make the necessary
adjustments for operation of the heater
and various units can be switched on
and off.
Please note!
The number of symbols and displays differs depending on the installed heater and
feature options.
Menu bar
Program bar
Display of the active
program memory and cor-
responding weekday
Back control key
Select a function in the
menu bar and adjust
values
Activation key
• Mobile unit – ON / OFF
• Switch over in the
display bar between
– Temperature
– Time
– Operating time
– Temperature setpoint value
• Switch back to the
menu bar
Display bar
Status display
Next control key
Select a function in the
menu bar and adjust
values
OK key
Select the flashing symbol
or confirm inputs
Key fob
5
Overview
Displays
Menu bar
Display bar
Heater ON / OFF
Ventilation ON / OFF
Add-on unit ON / OFF
Program preset time
Set the time / operating time
Set heating level
Program bar
Preset memory 1
Preset memory 2
Preset memory 3
Mo – So Weekdays
Mo – Su English weekdays
Please note!
• If the program number is underlined,
e. g. this program will be executed
next.
• “Ventilate” mode is not possible in all
heater models.
• The add-on unit function is not
possible with all heater models and
must be activated by the installation
workshop.
Numerical and text displays
AM Time in the morning (English)
PM Time in the afternoon (English)
°C Temperature in degrees Celsius
°F Temperature
in degrees Fahrenheit
Unlimited operating time
Heating level is set
Status display
Heating mode active
Ventilation mode active
Add-on unit active
Communication between
mobile unit and stationary unit
Battery charge status
6
Operation and Adjustment
Basic operation and adjustment rules
Activate mobile unit
Before each operation or setting, a con-
nection must be established between the
mobile unit and the stationary unit.
To do this, press until the menu bar
appears in the display, then release the
key and continue with the operation or
adjustment (see also page 8).
Switch off mobile unit / protect mobile unit against involuntary actuation
If is pressed for a long time the
display disappears, i.e. the mobile unit
is switched off and is therefore also pro-
tected against involuntary actuation.
Flashing symbols
Each flashing symbol
in the menu, program
and display bar can be
changed with or
and confirmed with .
Confirm input
The settings and changes must always
be confirmed with , otherwise they are
lost (exception: operating time).
Terminate/quit settings
You can use to terminate or quit
entering settings in a menu.
Display disappears
If a setting/adjustment or confirmation is
not made within 10 seconds the display
disappears, i.e. the mobile unit returns to
its normal condition.
For renewed input you must press
again.
Set operating time
(one-off or permanent)
The operating time can be individually set
with or .
In preset mode from 10 – 120 minutes.
In immediate operation from 10 – 120
minutes or continuous operation .
See pages 9, 10, 12 and 14 for a descrip-
tion.
Display during data transmission
During data transmission
(display SENd) the LED
display lighting switches
off.
After the data transmission has finished
the LED lighting is switched back on.
7
Operation and Adjustment
Activate mobile unit
Use the mobile unit to establish the connection with the
stationary unit.
press until the menu bar appears in the display. The
release the key. The symbol and text
appear briefly, then the temperature is displayed.
The radio remote control is activated.
Please note!
• If the key is not released after the menu bar ap-
pears the mobile unit switches itself off.
• During data transmission (display SENd) the display
lighting switches off. After the data transmission has
finished the display lighting is switched back on.
• Possible displays such as , and are de-
scribed in the chapter “What to do if …?” from page 23.
The following actions are possible:
• Switch over from temperature display to time and
back, press.
• Select functions in the menu bar with or ,
confirm selection with .
The further procedure is described in the relevant sec-
tion for the selected function.
Display
8
Operation and Adjustment
Set weekday, time and operating time
Activate mobile unit with (see page 8).
Select symbol with or .
Confirm selection with .
Select weekday with or .
Confirm selection with .
Set hours with or .
Confirm setting with .
Set minutes with or .
Confirm setting with .
Permanently set operating time for immediate operation
with or .
Confirm setting with .
The set, current time is displayed.
The adjustment is completed.
Display
The following action is possible:
• Select functions in the menu bar with or ,
confirm selection with .
The further procedure is described in the relevant sec-
tion for the selected function.
9
Loading...