Ebac K100H User Manual
Drawing : - TPC450
Issue : - 1
Date : - 18/01/16
K100H
DEHUMIDIFIER
OWNER’S MANUAL
www.eipl.co.uk
Page 1 of 16
Drawing : - TPC450
Issue : - 1
Date : - 18/01/16
K100H
PACKAGE CONTENTS
Item Description Quantity
10185GH-US Dehumidifier 1 off
3086144 Quick release hose coupling 1 off
3944110 PVC Tube – 3/8” I/D 7.8M
TPC450 Manual 1 off
Page 2 of 16
Drawing : - TPC450
Issue : - 1
Date : - 18/01/16
INTRODUCTION
Dehumidifiers remove moisture from the air that is circulating through the unit.
The resulting reduction of relative humidity helps prevent rust, rot, mold,
mildew and condensation within the room, or other enclosed spaces where
the dehumidifier is used.
A dehumidifier consists of a motor-compressor unit, a refrigerant condenser,
an air circulating fan, a refrigerated surface, a means of collecting and
disposing the condensed moisture and a cabinet to house these components.
The fan draws air through the refrigerated surface and cools it below its dew
point, removing moisture which is collected and led away. The cool air then
passes the hot condenser, where it is reheated. With the addition of other
radiated heat the air is discharged into the room at a higher temperature but
lower relative humidity than when the air entered the unit. Continuous
circulation of the room air through the dehumidifier unit gradually reduces the
relative humidity in the room.
A digital Humidistat is included which allows for precise humidity control. A
programmable display lets you set a specific desired humidity level.
The K100H dehumidifier is a rugged reliable drying unit designed to operate
effectively over a broad range of temperature and humidity conditions. A
powerful and reliable active hot gas defrost system, controlled by an
electronic timer, guarantees positive de-icing and thereby optimizing operation
at low temperatures.
The unit incorporates a welded steel chassis and is finished in vinyl coated
steel covers for resilience to damage caused by rough handling.
The K100H has a number of special features:
•
Ebac’s “Reverse Cycle” defrost system
•
Integral pump out system
•
Provision for permanent drainage
•
Exterior epoxy powder-coated finish
•
Extra long power cord
•
Free Standing or Wall Mountable
•
Status Indicator
•
Digital Humidistat Controller
Page 3 of 16
Drawing : - TPC450
Issue : - 1
Date : - 18/01/16
SPECIFICATIONS
M
ODEL
:
10185GH-US
H
EIGHT
: 27.2” (692mm)
W
IDTH
: 22.8” (580mm)
D
EPTH
: 18.3” (464mm)
W
EIGHT
: 117 Lbs (53Kg)
A
IRFLOW
P
OWER SUPPLY
P
F
R
EFRIGERANT TYPE/QTY
: 300 CFM (510 M3/Hr)
: 110V 1Ph 60Hz
OWER
INISH
1500 W (max)
: Epoxy coated steel
: R407C (540g)
"This product contains fluorinated greenhouse gases covered by the Kyoto Protocol. The
refrigeration system is hermetically sealed.
The Global Warming Potential (GWP) of refrigerants used in products manufactured by Ebac
Industrial Products Ltd is as follows
R134a – 1300
R407c – 1610
For type and weight of refrigerant contained in this unit, please refer to the product data label"
Page 4 of 16
Drawing : - TPC450
Issue : - 1
Date : - 18/01/16
INSTALLATION
POSITIONING:
Position the dehumidifier unit in the center of the room to be conditioned if at
all possible. However if a damp patch is particularly apparent the outlet grille
should be pointed towards it.
NOTE: Both inlet grille and outlet grille of the dehumidifier unit must have
clear space around them and not be obstructed in anyway.
WIRING:
Connect the power mains cable to a designated 30 Amp breaker. As follows:-
For Models without plugs:-
Brown Live
Blue Neutral
Green/Yellow Earth (ground)
DRAINAGE:
The K100H has a water pump fitted as standard which is capable of
discharging the condensate water 20ft vertical lift away from the unit & 100ft
horizontal. The water can, therefore, be discharged into a drain some distance
away.
Page 5 of 16
Loading...