Drawing : - TPC112
Issue : - 5
Date : - 09/12/13
CCCCD100
D100
D100D100
DEHUMIDIFIER
DEHUMIDIFIER
DEHUMIDIFIERDEHUMIDIFIER
OWNER’S MANUAL
OWNER’S MANUAL
OWNER’S MANUALOWNER’S MANUAL
www.eipl.co.uk
Page 1 of 16
Drawing : - TPC112
Issue : - 5
Date : - 09/12/13
CD100
PACKAGE CONTENTS
Item Description Quantity
1133560 Dehumidifier 1
3014338 PVC Tube – 12mm I/D 3M
3086101 Jubilee clip 1
TPC112 Manual 1
Page 2 of 16
Drawing : - TPC112
Issue : - 5
Date : - 09/12/13
INTRODUCTION
Dehumidifiers remove moisture from the air that is circulating through the unit.
The resulting reduction of relative humidity helps prevent rust, rot, mould,
mildew and condensation within the room, or other enclosed spaces where
the dehumidifier is used.
A dehumidifier consists of a motor-compressor unit, a refrigerant condenser,
an air circulating fan, a refrigerated surface, a means of collecting and
disposing the condensed moisture and a cabinet to house these components.
The fan draws air through the refrigerated surface and cools it below its dew
point, removing moisture which is collected and led away. The cool air then
passes the hot condenser, where it is reheated. With the addition of other
radiated heat the air is discharged into the room at a higher temperature but
lower relative humidity than when the air entered the unit. Continuous
circulation of the room air through the dehumidifier unit gradually reduces the
relative humidity in the room.
The CD100 dehumidifier is a rugged reliable drying unit designed to operate
effectively over a broad range of temperature and humidity conditions. A
powerful and reliable active hot gas defrost system, controlled by an
electronic timer, guarantees positive de-icing and thereby optimising operation
at low temperatures.
The unit incorporates a welded steel chassis and is finished in vinyl coated
steel covers for resilience to damage caused by rough handling.
Page 3 of 16
Drawing : - TPC112
Issue : - 5
Date : - 09/12/13
SPECIFICATIONS
M
ODEL
: CD100
H
EIGHT
: 406mm (16”)
W
IDTH
: 914mm (36”)
D
EPTH
: 508mm (20”)
W
EIGHT
: 61 Kg (135 lbs)
A
IRFLOW
P
OWER SUPPLY
P
F
R
EFRIGERANT TYPE/QTY
M
OBILITY
: 1190 M3/hr (700 cfm)
UK-220V/240V, 1 ph, 50Hz/60Hz
:
USA-110V/120V, 1 ph, 50Hz/60Hz
OWER
INISH
1090 W (max)
: Vinyl coated steel
: R407c (540g)
Choice of aids – wheels or skid
:
handles
"This product contains fluorinated greenhouse gases covered by the Kyoto Protocol. The
refrigeration system is hermetically sealed.
The Global Warming Potential (GWP) of refrigerants used in products manufactured by Ebac
Industrial Products Ltd is as follows
R134a – 1300
R407c – 1610
For type and weight of refrigerant contained in this unit, please refer to the product data label"
Page 4 of 16
Drawing : - TPC112
Issue : - 5
Date : - 09/12/13
INSTALATION
POSITIONING:
Position the dehumidifier unit in the center of the room to be conditioned if at
all possible. However if a damp patch is particularly apparent the outlet grille
should be pointed towards it.
NOTE: Both inlet grille and outlet grille of the dehumidifier unit must have
clear space around them and not be obstructed in anyway.
WIRING:
Connect the power mains cable to a 13 Amp power supply. As follows:-
Brown Live
Blue Neutral
Green/Yellow Earth (ground)
DRAINAGE:
Connect a 15mm inside diameter hose to the water outlet pipe. Secure the
hose using a worm drive clip. The hose should at no point be raised higher
than the outlet pipe. Failure to observe this requirement will result in flooding
of the dehumidifier unit.
The CD100 may also be fitted with a water pump (optional), which is capable
of discharging the condensate water 30ft away from the unit. The water can,
therefore, be discharged into a drain some distance away.
Page 5 of 16
Loading...