Eaton Room Controller QuicKit Technical Data

Technical Data

Effective March 1, 2018

Room Controller QuicKit

Catalog# Prepared by

Project Date

Comments Type

Overview

The Room Controller QuicKits provide a complete, all-in-one package
solution. Easy to order, QuicKits are designed and packaged for
immediate in-room installation.

The Room Controller includes three relays and up to three 0-10
VDC dimming outputs to control compatible dimmable ballasts. The
switching relays and 0-10 VDC outputs are controlled separately,
allowing flexibility in wiring and control. The Room Controller is
shipped preconfigured to work out-of-the-box when connected
to Room Controller devices, allowing quick and easy daylighting
controls, occupancy/vacancy sensing and manual switching.

Features

Packages for Conference Rooms, Offices, Classrooms, and
Healthcare

Click & Go ready, RJ45 connections

Preconfigured for automatic functionality upon power-up

Manual or Automatic On, bi-level, tri-level and dimming control
strategies

Integral Demand Response input with four levels of preconfigured
energy reduction

Built in tubular lighting control with preconfigured wallstation
controls

Integral pillow speaker connections for GPCS (RC3DEHC)

Integral Solatube® connection for classrooms

Guaranteed compatibility with Eaton LED and 0-10V fluorescent
fixtures

Ladderless UL 924 Emergency Mode testing (RC3DE &
RC3DEHC)

March 2018

Room Controller QuicKit

Specifications

QuicKit Size 8.5”H x14”W x11”D
Input/Output

Voltage

Emergency
Output (RC3DE/
RC3DEHC only)
UL 924

Class 2 Dimming
Output

LED Drivers Requires isolated LED drivers for optimal

Operating
Environment

Standards UL Approved

120/277 VAC, 60Hz

Maximum 20A combined load per Room Controller

Ballast load: 20A @ 120/277 VAC (LED)

Incandescent load: 15A @ 120 VAC

Motor load: 1HP @ 120 VAC

LED, Ballast or Incandescent load: 3A

0-10 VDC, sinks up to 100mA per (40 µA max per
circuit leakage to line)

Each 0-10V output supports up to 50 ballasts/
drivers that draw the standard 2mA each

performance

Temperature: 32°F to 104°F (0°C to 40°C)

For indoor use

UL 508 Listed
UL 924 Listed

Description/Operation

The Room Controllers are connected to a 120 VAC or 277 VAC 20
Amp circuit to provide unit power and input power to the individual
relays. The wallstations, occupancy/vacancy sensors, daylight
sensors and receptacle control devices connect via QuickConnect
cables providing a Class 2 connection. Upon power up the pre­engraved wallstation automatically controls the On/Off relays
and/or adjust the dimming outputs. The daylight sensor will
immediately adjust the lighting levels based on natural light.

Installation

The line voltage section of the Room Controller provides the
installing contractor space to make all line voltage connections and
direct conduit access, reducing the need for additional junction
boxes, while providing easy access to line voltage circuits. Low
voltage devices are connected using Cat5 cables (See page 4 for
included cables).

UL 924 relay is provided on some units for automatic emergency
lighting control. The UL 924 relay automatically tracks with output 1
and can be connected to any of the three 0-10V dimmers. The
UL 924 relay automatically closes and disconnects the 0-10V control
upon loss of normal power providing adequate egress lighting
control. Ladderless maintenance testing of the UL 924 relay can be
acheived by pressing the ALL OFF button four times.

2

www.eaton.com/lightingsystems