Earlex ASG55 - AUTRE, Super Sprayer ASG55 Operating Instructions Manual

Thank you for purchasing an Earlex Electric Airless Spray Gun.

Please read all these instructions before operating

this product and retain them for future reference.

Earlex Ltd will accept no responsibility for the use of this product if used

for any other purposes than those detailed herein.

MODEL ASG55

OPERATING INSTRUCTIONS

 Keep work area clean - Cluttered areas and benches

invite injuries.

 Consider work area environment - Do not expose the

spray gun to rain. Do not use the spray gun in damp
or wet locations. Keep work area well lit.

 G

uard against electric shock - Avoid body contact with
earthed or grounded surfaces (e.g. pipes, radiators,
ranges, refrigerators).

 Keep children away away from the spray gun.

 When not in use, spray gun should be stored in a dry,

high or locked place, out of reach of children.

 Use the spray gun for the job it was designed for only.

Mis-use of the spray gun will invalidate the guarantee.

 Dress properly - do not wear loose clothing or

jewellery, they can be caught in moving parts. Rubber
gloves and non-skid footwear are recommended when
working outdoors. Wear protective hair covering to
contain long hair.

 Always wear a mask when spraying.

 We recommend the use of eye protection to keep

hazardous vapours out of eyes.

 We recommend the use of ear protectors.

 Do not abuse the cord - Never carry the tool by the

cord or pull it to disconnect it from the socket. Keep
the cord away from heat, oil and sharp edges.

 Do not overreach - Keep proper footing and balance

at all times.

 Always disconnect from mains supply when not in

use, when refilling the paint container and before
cleaning.

 Avoid unintentional starting, do not carry a plugged in

tool with a finger on the switch.

 When tool is used outdoors, use extension cords only

intended for outdoor use.

 It is recommended that a RCD (residual current

device) rated at 30mA is fitted into the mains supply
socket for added protection against electric shock.

 Stay alert - Watch what you are doing. Use common

sense and do not operate tool when you are tired.

 Never under any circumstances aim the nozzle at

another person or animal. In the event of injury
occuring seek expert medical advice immediately.

 Always keep the spray nozzle in place during

use. Never allow the spray nozzle to come in direct
contact with the skin.

 Always ensure there is adequate ventilation when

spraying.

 Never spray near a source of ignition, e.g. hot

surfaces, sparks, cigarettes, glowing wires & open
flames including appliance pilot flame.

 T

he spray gun must not be used for spraying

flammable materials having a flash point below 21˚C.

 Always beware of any hazards presented by the

material being sprayed and consult the markings on
the container or the information supplied by the
manufacturer of the material to be sprayed, including
requirements for the use of personal protective
equipment. Do not spray any material where the
hazard is not known.

 The spray gun must not be cleaned with flammable

liquids having a flash point below 21˚C.

 Check for damaged parts - Before further use of the

spray gun, a guard or other part that is damaged should
be carefully checked to determine that it will operate
properly and perform its intended function. Check for
alignment of moving parts, free running of moving
parts, breakage of parts, mounting and any other
conditions that may affect its operation. A guard or
other part that is damaged should be properly
repaired or replaced by an authorized service centre
unless otherwise indicated in this instruction manual.
Have defective switches replaced by an authorized
service facility. Do not use the tool if the switch does
not turn it on and off.

 Warning - The use of any accessory or attatchment,

other than those recommended in this instruction
manual, may present a risk of personal injury.

 Maintain tools with care - Follow instructions for

lubrication and changing the accessories, inspect tool
regularly and if damaged, get repaired by an
authorized service centre.

 Have your tool repaired by a qualified person – This

electric tool is in accordance with the relevant safety
requirements. Repairs should only be carried out by
qualified persons using original spare parts, otherwise
this may result in considerable danger to the user.

 Do not spray any material where the hazard is

not known.

 Use genuine Earlex parts only.

 This appliance is not intended for use by persons

(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.

WARNING: When using the Spray Gun, basic safety precautions, including the
following, should always be followed to reduce the risk of fire, electric shock and
personal injury.

NOISE AND VIBRATION LEVELS

The following values were measured in accordance with EN50144-2-7
A-weighted sound power level: 99.9dB(A)

Vibration level: 8.824 m/s

2

2

SAFETY OPERATING INSTRUCTIONS

1. 1.0mm Nozzle SG209

2. 0.6mm Nozzle SG211

3. Piston Spring 55W SG234

4. Piston Assembly SG237

5. Suction Tube and Filter Assembly SG240

6. 1.0 Litre Paint Container SG242

7. Valve Assembly - Pack of 3 SG310

8. Viscosity Cup SG243

9. Lubricating Oil SG244

6

8

3

7

* Circled numbers need to be cleaned after every use.

1/2

4

5

3

PARTS AND ACCESSORIES

9

TO OBTAIN THE BEST RESULTS FROM YOUR SPRAY GUN READ THESE INSTRUCTIONS

CAREFULLY BEFORE USE.

The Spray Gun can be used to spray many different materials including varnishes, wood preservatives,
enamel paints, oil based paints and water based paints.
The Spray Gun can be used for a variety of applications including, fences, sheds, boats, furniture,
radiators, models and louvre doors.

PLEASE NOTE

We have done all we can to ensure that used correctly and according to these instructions, the Earlex
Electric Airless Spray Gun will give long trouble free service. We accept no responsibility for damage
caused by the use of incorrect or unsuitable substances, paint or fluids which have not been thinned
correctly or are unsuitable for the surfaces to which they are applied, health hazards arising from lack
of ventilation when working in confined spaces, or failure of the equipment due to inadequate cleaning
of components after use.
If in doubt, always test a small inconspicuous area first. Always read the paint manufacturer’s
instructions first.
Neither our guarantee nor the above statement affect your statutory rights.

IMPORTANT - Selecting the paint

Many paints and other materials can be sprayed but some cannot. Always check the manufacturer’s
recommendations before using products with your Spray Gun.

THE SPRAY GUN MUST NOT BE USED FOR SPRAYING EXTERIOR TEXTURED WALL PAINTS OR
TEXTURED COATINGS. USING THESE MATERIALS WILL CAUSE PREMATURE WEAR ON THE
PISTON AND WILL INVALIDATE YOUR GUARANTEE.

IF YOU HAVE ANY PROBLEMS WITH YOUR SPRAY GUN OR IF YOU BELIEVE A PART IS
MISSING, DO NOT RETURN TO STORE. PLEASE CONTACT EARLEX LTD ON 01483 454666.

SAFETY WARNING LABEL

One of the labels on the Spray Gun is a warning label and shows three diagrams. If you are in any
doubt about their meaning, please see the explanation below:

<21˚C

Do not direct the Spray Gun

at yourself or anyone else.

(Risk of injection).

Do not use your Spray Gun

in wet weather.

Do not use your Spray Gun for

spraying flammable materials. i.e

those with a flashpoint less than

21˚C.

4

ABOUT THE SPRAY GUN