2008 Kawasaki ZX10R
Installation Instructions
Parts List
1 Power Commander
1 USB Cable
1 CD-ROM
1 Installation Guide
1 Power Adapter
2 Power Commander Decals
2 Dynojet Decals
2 Velcro®Strip
1 Alcohol Swab
The ignition MUST be turned
OFF before installation!
You can also download the Power
Commander software and latest maps
from our web site at:
www.powercommander.com
Button Adjustment Display
Faceplate Buttons
Expansion Port
USB Port
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com
i233-411 www.powercommander.com 2008 Kawasaki ZX10R - PCIII USB - 1
1. Remove the main seat and the
passenger seat
Fig. AFig. B
Remove covers
Remove pins
2 Remove the right hand side tail sec-
tion (Fig. A).
3 Prop the front of the fuel tank up.
4 Remove the pins on the underside tail
section (Fig. B).
Fig. C
i233-411 www.powercommander.com 2008 Kawasaki ZX10R - PCIII USB - 2
5 Route the PCIII harness between the
underside tail section and subframe
(Fig. C).
PCIII harness
Continue routing the harness down
the right hand side of the bike towards
the throttle bodies.
Unplug connector
6 Unplug the main wiring harness from
the throttle bodies (Fig. D).
Fig. DFig. E
This is a 16 pin BROWN connector
located under the fuel tank on the
right hand side of the bike
PCIII connectors
7 Plug the PCIII connectors in-line of
the stock wiring harness and throttle
body harness (Fig. E).
Stock connectors
PCIII ground wire
Fig. F
i233-411 www.powercommander.com 2008 Kawasaki ZX10R - PCIII USB - 3
8 Attach the ground wire of the PCIII
to the negative side of the battery
(Fig. F).
9 Using the supplied velcro attach the
PCIII to the inner part of the right
hand fairing (Fig. G).
Fig. G
Use the alcohol swab to clean both
surfaces before attaching.
10 Reinstall all bodywork and fuel tank.
i233-411 www.powercommander.com 2008 Kawasaki ZX10R - PCIII USB - 4
Loading...