Dynojet Power Commander III User Manual

2005 Benelli TNT 1130

Installation Instructions

Parts List

1 Power Commander
1 USB Cable
1 CD-ROM
1 Installation Guide
1 Power Adapter
2 Power Commander Decals
2 Dynojet Decals
2 Velcro®Strip
1 Alcohol Swab

Button Adjustment Display

Faceplate Buttons

Expansion Port

The ignition MUST be turned

OFF before installation!

You can also download the Power
Commander software and latest maps
from our web site at:

www.powercommander.com

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION

USB Port

Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 [phone] www.powercommander.com

i726-411 www.powercommander.com 2005 Benelli TNT 1130 - PCIII USB - 1

1 Remove the seats

Fig. AFig. B

Ground wire from PCIII

2 Remove the fuel tank.

3 Mount the Power Commander on top

of the battery using the supplied vel­cro. Use the alcohol swab to clean
both surfaces before attaching (Fig. A)

4 Attach the ground wire of the PCIII to

the negative side of the battery.

5 Route the Power Commander harness

along the right side of the ECU and
the subframe and go towards the
thorttle bodies (Fig. B).

Fig. C

Ground wire from PCIII

Unplug the stock harness

6 Unplug the stock wiring harness from

each injector (Fig. C).

i726-411 www.powercommander.com 2005 Benelli TNT 1130 - PCIII USB - 2

Fig. DFig. E

7 Plug the PCIII connectors in-line of

the stock wiring harness and injectors
(Fig. D).

ORANGE - right cylinder

YELLOW - middle cylinder

GREEN - left cylinder

Align the PCIII connector to the stock
wiring harness as shown below. The
square edges of the PCIII connector
align with the spring clip side of the
stock wiring harness

Unplug the TPS

PCIII

square edges

Stock

Spring clip

8 Locate the Throttle Position Sensor

connector. This is located on the right
hand side of the throttle bodies
(Fig. E).

9 Unplug this connector and plug the

connectors from the PCIII in-line of
the stock wiring harness and TPS.

10 Install the fuel tank. Make sure that

the PCIII harness does not get
pinched by the fuel tank.

11 Install the seats.

i726-411 www.powercommander.com 2005 Benelli TNT 1130 - PCIII USB - 3