Dynojet Dynoware RT User Manual

OBD2 Data-Link Interface User Guide

The DynoWare RT OBD2 Data-Link Interface plugs directly into the CAN-based vehicle's OBD2 port and brings data from the vehicle's ECM

directly into DynoWare RT. The OBD2 engine RPM channel can be used as your dyno's primary RPM signal.

Data can be viewed in real-time and saved with the dyno graph.

Connecting the OBD2

DynoWare RT - OBD2 Data-Link

1. Verify the vehicle is grounded to the dyno.
Note: To avoid damage to the OBD2 Data-Link and your vehicle,
the vehicle must be grounded to the dyno.

2. Locate the OBD2 port on the vehicle.

3. Connect the Data-Link to the OBD2 port on the vehicle.

4. Connect the OBD2 cable to the Data-Link.

5. Connect the OBD2 cable to the powersports port on the

DynoWare RT main module.

OBD2 Configuration

1. Start the vehicle.

2. Start Power Core software.

3. Click WinPEP 8 Dyno Control from the Application Launcher.

4. Connect to the DynoWare RT.

5. Click the Configuration tab.

6. Click RPM Configuration.

7. Select OBD2 from the RPM Source drop-down list.

8. Click OK.

For more information, refer to WinPEP 8 Dyno Control Help.

A

98200066.02

• All vehicles model year 2008 and newer manufactured or imported to
North America.

• Most post 2003 vehicles that have the OBD2 pins populated for CAN.

Vehicle Compatibility

CAN Pin Locations

Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081

1-800-992-4993 www.dynojet.com