Thank you for purchasing the DX-S1000 Car Audio Speakers. Although Dynex has attempted
to m ake sure a ll of the i nform ation contained w ithin t his manu al is accurate, pl ease be awa re
that any part of it is subjec t to change without notice.
Important safety instructions
Contents
This symbol alerts the user to the presence of important
instructions. Failure to heed these instructions can result in injury
or damage to the speakers.
If you feel unsure about installing this system yourself, have it
installed by a qualified audio technician.
Before installation, disconnect the battery negative (-) terminal to
prevent damage to the speakers, fire and/or possible injury.
Setting up the car audio speakers
The following are basic installation instructions. If you feel unsure
about personally installing this speaker system, Dynex
recommends using the services of a professional car audio
installation center.
Mounting the car audio speakers
Before installation, follow these guidelines:
1 Carefully read and understand the instructions before installing this product.
2 Disconnect the negative terminal from the battery before installing this product.
3 If additional wiring is needed, we recommend running all wires prior to mounting
your speaker in place.
4 Use the highest quality connectors for a reliable installation and to minimize signal or
power loss.
5 Use caution before you drill or cut. Be careful not to cut or drill into gas tanks, fuel
lines, brake or hydraulic lines, vacuum lines or electrical wiring when working on any
vehicle.
6 Never run speaker wires underneath your vehicle. Running speaker wires inside the
vehicle provides the best protection from exhaust heat and environmental elements.
7 Avoid running wires over, near, or through sharp edged sur faces. Use rubber grommets
to prot ect any wires routed through metal, especially the firewall.
8 When running the speaker cable from the amplifier, avoid running it near sources of
high current (i.e. wiring harnesses, battery cables).
Mounting the car audio speakers
Standard rear
deck installation
Grille
Mounting
ring
Speaker
Mounting
hole cut-out
3
Standard door
installation
Grille
Mounting
ring
Speaker
Mounting
hole cut-out
To mount the car audio speakers:
1 Determine where the speakers will be mounted. Make sure the area is large enough
for the speaker to mount evenly and deep enough for the speaker to fit.
2 Refer to the specification chart on the following page to determine the proper
diameter hole to cut for your speaker model.
3 If supplied, use the plastic mounting ring as a template to mark the locations for the
mounting screws.
4 Drill the holes with a 1/8" bit.
5 Be sure to observe proper polarity when connecting the wires. The speaker's positive
terminal is indicated with a "+".
4
Legal notice
6 Fit the ring and speaker to the cutout. Mount them using the enclosed screws. If
supplied, fit the grille inside the ring and press gently, but firmly, into place.
Mounting height
Top-mounting depth
Cut-out diameter
Tweeter protrusion
Bottom-mounting depth
The diagram featured above is to be used in conjunction with the specifications guide below:
SpecificationMeasurement
Mounting height
Top-mounting depth2 ¼
Tweeter protrusion¼
Bottom-mounting depth2
Cut-out diameter5 ½
Sensitivity (dB)86
Frequency response80-20 K
Recommended power (watts RMS)60
Peak power handling (watts IPP)120
Grille (yes or no)Yes
Dynex Products (“Dynex”) warrants to you, the original purchaser of this new car audio
speakers (“Product”), that the Pro duct shall be free of defects in the original manufacture
of the material or workmanship for a period of 90 days from the date of your purchase of
the Product (“Warranty Period”). This Product must be purchased from an authorized
dealer of Dynex brand products and packaged with this warranty statement. This warranty
does not cover refurbished Product. If you not ify Dynex during the Warranty Period of a
defect covered by this warranty that requires service, terms of this warranty apply.
HOWLONGDOESTHECOVERAGELAST?
The Warranty Period la sts for 90 days from the date you purchased the Product. The
purchase date is printed on the receipt you received with the product.
WHATDOESTHISWARRANTYCOVER?
During the Warranty P eriod, if the original manufacture of the mat erial or workm anship of
the Product is determined to be defective by an authorized Dynex repair center or store
personnel, Dynex will (at its sole option): (1) repair the Product with new or rebuilt parts; or
(2) replace the Product at no charge with new or rebuilt comparable products or parts.
Products and parts replaced under this warranty become the property of Dynex and are
not returned to you. If service of Products and parts are required after the Warranty Period
expires, you must pay all labor and parts charges. This warranty lasts as long as you own
your Dynex Product during the Warranty Period. Warranty coverage terminates if you sell
or otherwise transfer the Product.
HOWTOOBTAINWARRANTYSERVICE?
If you purchased the Product at a retail store location, take your original receipt and the
Product to the stor e you purchased it from. Make sure that you place the Product in its
original packaging or packaging that provides the same amount of protection as the
original packaging. If you purchased the Product from an online web site, mail your
original receipt and the Product to the address listed on the web site. Make sure that you
put the Product in its original packaging or packaging that provides the same amount of
protection as the original packagin g.
WHEREISTHEWARRANTYVALID?
This w ar ra nt y is v ali d on ly to the or ig in al pu r cha se r of th e Pr od uct in th e Un it ed Sta tes and
Canada.
WHATDOESTHEWARRANTYNOTCOVER?
This warranty does not cover:
•
Customer instruction
•
Installation
•
Set up adjustments
•
Cosmetic damage
•
Damage due to acts of God, such as lightning strikes
•
Accident
•
Misuse
•
Abuse
•
Negligence
•
Commercial use
•
Modification of any part of the P roduct
This warranty also does not cover:
•
Damage due to incorrect operation or maintenance
•
Conne c tio n t o an incorrect voltage su pp ly
5
6
•
Attempted repair by anyone other than a faci lity author ized by Dynex to service the
Product
•
Products sold as is or with all faults
•
Consumables, such as fuses or batteries
•
Products where th e factory applied serial number has been altered or removed
REPAIR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS YOUR
EXCLUSIVE REMEDY. DYNEX SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR
CONSEQUENTIAL DAMAGES FOR THE BREACH OF ANY EXPRESS OR IMPLIED
WARRANTY ON THIS PRODUCT, INCLUDING, BUT NOT LIMITED TO, LOST DATA,
LOSS OF USE OF YOUR PRODUCT , LOST BUSINESS OR LOST PROFITS. DYNEX
PRODUCTS MAKES NO OTHER EXPRESS WARRANTIES WITH RESPECT TO THE
PRODUCT, ALL EXPRESS AND IMPLIED WARRANTIES FOR THE PRODUCT,
INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTIES OF AND
CONDITIONS OF MERCHANTABILITY AND FITNESS FOR A P ARTI CULAR PURPOSE,
ARE LIMITED IN DURATION TO THE WARRANTY PERIOD SET FORTH ABOVE AND
NO WARRANTIES, WHETHER EXPRESS OR IMPLIED, WILL APPLY AFTER THE
WARRANTY PERIOD. SOME STATES, PROVINCES AND JURISDICTIONS DO NOT
ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE
ABOVE LIMITATION MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU
SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS, WHICH
V ARY FROM STATE TO STATE OR PROVINCE TO PROVINCE.
Contact Dynex :
For customer service please cal l 1-800-305-2204
www.dynexproducts.com
®
DYNEX
Distributed by Best Buy Purchasing, LLC.
Dynex, 7601 P enn Avenue South, Richfield, Minnes ota, U.S.A.
is a registered tra demark of Best Buy Enterprise Servi c es, Inc.
90 Day Limited Warranty
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.