Dynacord CL 2000, CL 1200 User Manual

OWNER‘S MANUAL

to constitute a risk of electric shock to persons.

the literature accompanying the appliance.

4.

with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide

To completely disconnect this equipment from the AC Mains, disconnect the power plug from the AC receptacle.

The mains plug of the power supply cord shall remain readily operable.

These servicing instructions are for use by quali ed personnel only. To reduce the risk of

The minimum distance between parts carrying mains voltage and any accessible metal piece (metal enclosure),

Altering the circuitry without prior consent or advice is not legitimate.

Any work security regulations that are applicable at the location where the appliance is being serviced have to be

All instructions concerning the handling of MOS - circuits have to be observed.

With buying a DYNACORD CL-SERIES power ampli er you have chosen an appli-

weight and power dissipation.

fast, signal-dependent operating voltage switching, which results in doubling the regular supply voltage

when needed. Compared to Class-AB power amps, Class-H power amps generate by far less power

the risk of the output transistors being damaged by electrical energy back-feed. The power outputs are

front panel. CL-Series power amps provide the opportunity for retro tting an internal analogue signal

4

x 330mm

(up to the cabinet’s top ventilation louvers) for air circulation between the rear of the power

to “MAINS OPERATION AND RESULTING TEMPERATURE”).

warmer environment. In that case operation is only permissible after the appliance has gained the