Dwyer MW-1 User Manual

FEATURES:

• Wind speed measure in mph, Km/h, m/s, Knots, ft/min

• Measure in current/Ave./Max

• Wind speed bar graph

• Wind chill display

• Temperature display in degrees

Celsius or Fahrenheit

• LCD backlight

• 14 minute auto power OFF

• Neck band included

• Water resistant housing

• 3V lithium battery CR2032 operation (battery not included)

Electronic Anemometer

Model MW-1

Electronic Anemometer

SPECIFICATIONS

Wind speed range

Unit

Range

M/s

Ft/min

0-5860

Knots

Km/hr

Mph

Temperature range

Unit

°F °C

Temperature Limits: 14 to 113°F (-10 to 45°C). Humidity Limit: ≤90% RH. Power Supply: CR2032, 3.0 V battery. Display: 2.32 x 2 in (59 x 51 mm). Housing: Water resistant polycarbonate. Weight: 1.84 oz (52.1 g). Agency Approvals: CE.

DIRECTIONS

1) Turn on: Hold ‘MODE’ for 2 seconds.

2) Turn off: Press ‘MODE’ and ‘SET’ together. Auto

shut-off is 14 minutes.

3) Activate LCD unit: Press any button to turn on LCD back-light. LCD shuts off after 12 seconds.

4) Changing wind units: Hold ‘Mode’ for 3 seconds until display blinks. Press ‘SET’ to select desired wind speed unit. Once selected press ‘Mode’ to accept.

5) Change between current/ Ave./ Max: Same as #4’s “Changing wind units.” Continue to press ‘SET’ until ‘Cu’ is displayed on LCD, followed by ‘MAX’, then ‘AVE’. Press ‘MODE’ to accept.

6) Measurement: When the wind impeller spins, the LCD will display wind speed and temperature. If below 32°F (0°C), wind chill symbol will be displayed on LCD.

FR# R8-443429-00 Rev. 1

0-30

0-55 0-90 0-65

14 to 113°F

-10 to 45°C

Resolution

0.1 19

0.2

0.3

0.2

Range

Threshold

0.1 39

0.1

0.3

0.2

Resolution

0.36

0.2

Accuracy

±5%

Accuracy

±3.6°F

±2°C

Model MW-1

DIRECTION TO USE:

• Insert New 3V lithium battery CR2032 into battery compartment.

• To change temperature units (°F/°C) use pushpin through hole on back of unit.

MADE IN CHINA