Duro-Last Vinyl-Coated Drip Edge User Manual

DATA SHEET

Material

Gauge

Finish

Galvalume

24-gauge

PVC

Vinyl-Coated Drip Edge

Description:

The Vinyl-Coated Drip Edge provides maximum water
flow from roof decks while providing an architectural,
visually-attractive termination.

Fabricated from vinyl-coated metal with a 6”

attached membrane skirt in 10’ lengths; 2” – 8”
widths.

Profiles can be custom-fabricated to meet most

specifications.

Can be fabricated to accommodate various roof

pitches and mansards with a maximum face size
of 8”.

Available in white, tan, gray, or dark gray and

can be painted with latex or acrylic paint to
match building design.

Contact Duro-Last® or EXCEPTIONAL® Metals to
request a color chart, samples and information
regarding custom metals and finishes.

Energy Efficiency:

LEED® and ENERGY STAR® compliant; Recyclable.

Installation:

1. A wood nailer is required if 1” or greater of
insulation is used.

2. This nailer should be attached to the wall in
accordance with ANSI/SPRI ES-1 3.9.

3. Install in accordance with Duro-Last detail
drawing #3120.

4. Any deviation from the requirements set forth in
the detail drawings must be pre-approved, in
writing, by the EXCEPTIONAL Metals Technical
Department.

Warranty:

Duro-Last offers a wide range of warranty coverage for
EXCEPTIONAL Metals products when used with the
Duro-Last roofing system, including paint and finish.

Technical Services:

Product samples, detail sheets, color chips, and color
chart are available for your submittal package. For
assistance with questions or submittals, contact your
local representative or call EXCEPTIONAL Metals.

“Duro-Last” and “EXCEPTIONAL” are registered marks owned by Duro-Last Roofing, Inc. Revised 8/30/2012