T-Edge Plus
Description:
The T-Edge Plus is designed with a double-folded drip
edge neatly concealing the vinyl-coated hook strip so it
is not visible from ground level. The system consists of
three separate components: a drip edge base, hook
strip, and splice plate that are hooked together to form
an aesthetically-pleasing edge.
Fabricated in 10’ lengths; 2” – 8” widths.
Top piece consists of a vinyl-coated hook strip
with a 6” attached membrane skirt. Bottom drip
edge piece available in any metal finish.
Does not require an overlapping allowance.
Ready to assemble inside and outside corners
are available.
Contact Duro-Last® or EXCEPTIONAL® Metals to
request a color chart, samples and information
regarding custom metals and finishes.
Energy Efficiency:
LEED® and ENERGY STAR® compliant; Recyclable.
Installation:
1. Attach to a wood nailer.
2. This nailer should be attached to the wall in
accordance with ANSI/SPRI ES-1 3.9.
3. Install in accordance with Duro-Last detail
drawing #3555.
4. Any deviation from the requirements set forth in
the detail drawings must be pre-approved, in
writing, by the EXCEPTIONAL Metals Technical
Department.
Codes and Standards:
Product samples, detail sheets, color chips, and color
chart are available for your submittal package. For
assistance with questions or submittals, contact your
local representative or call EXCEPTIONAL Metals.
Warranty:
Duro-Last offers a wide range of warranty coverage for
EXCEPTIONAL Metals products when used with the
Duro-Last roofing system, including paint and finish.
Technical Services:
“Duro-Last” and “EXCEPTIONAL” are registered marks owned by Duro-Last Roofing, Inc. Revised 8/30/2012
ANSI/SPRI ES-1 Compliant for 3” – 8” in 24-
gauge galvanized and .040 aluminum.