T-Edge
Description:
The T-Edge provides a smooth edge finish and easy deck
termination. The system consists of three separate
components: a drip edge base, hook strip, and splice plate
that are hooked together to form an aesthetically-pleasing
edge.
Fabricated in 10’ lengths; 2” – 8” widths.
Can be modified to accommodate various pitches
and bend up to a 6/12 slope.
Top piece consists of a vinyl-coated hook strip with
a 6” attached membrane skirt. Bottom drip edge
piece available in any metal finish.
Does not require an overlapping allowance.
Ready to assemble inside and outside corners are
available.
Contact Duro-Last® or EXCEPTIONAL® Metals to request
a color chart, samples and information regarding custom
metals and finishes.
Energy Efficiency:
LEED® and ENERGY STAR® compliant; Recyclable.
Installation:
1. Attach to a wood nailer.
2. This nailer should be attached to the wall in
accordance with ANSI/SPRI ES-1 3.9.
3. Install in accordance with Duro-Last detail drawing
#3550.
4. Any deviation from the requirements set forth in the
detail drawings must be pre-approved, in writing, by
the EXCEPTIONAL Metals Technical Department.
Codes and Standards:
Technical Services:
Product samples, detail sheets, color chips, and color
chart are available for your submittal package. For
assistance with questions or submittals, contact your local
representative or call EXCEPTIONAL Metals.
Warranty:
Duro-Last offers a wide range of warranty coverage for
EXCEPTIONAL Metals products when used with the
Duro-Last roofing system, including paint and finish.
“Duro-Last” and “EXCEPTIONAL” are registered marks owned by Duro-Last Roofing, Inc. Revised 8/30/2012
ANSI/SPRI ES-1 Compliant for 3” – 8” in 24-
gauge galvanized and .040 aluminum.
Meets TAS 111-95 test for 4”.