Duro-Last Gravel Stop - Metal Cover User Manual

DURO-LAST® GRAVEL STOP
with Metal COVER
DATA SHEET
Duro-Last® Gravel Stop with Metal Cover may be used
as a perimeter flashing for the Duro-Last roofing system. The system consists of Duro-Last Gravel Stop and a snap-on m etal cov er. The system has been approved by FM Approvals as a Class 1-930 perimeter flashing.
Duro-Last Gravel Stop is fabricated from rigid exterior
vinyl and includes a 6 inch (152 mm) wide skirt made of Duro-Last specially formulated roofing membrane which is a proprietary thermoplastic formulation. Both the rigid vinyl and the skirt are available in white, gray, and tan colors. Combinations of the colors (tan face with white skirt, for example) are available upon request.
Duro-Last Gravel Stop is 10 feet long an d available in two widths: 2 inches (51 mm) and 4 in c h es (102 mm). The Gravel Stop has pre-punched slott ed holes 8 inches (203 mm) on center for fastening.
The metal cover is 10 feet long and available in
24-gauge galvalume st eel with 35 stocked finishes as well as in these s p ecialized metals:
* .040 aluminum wit h Kynar finish. * .040 aluminum wit h mi ll f in is h. * 16- oz. copper. * 24- ga uge stainless st eel.
* 24-gauge bonderized (paintable) steel. Contact Duro-Last, Inc. to request a color chart, samples and information regarding custom metals and finishes.
7. The metal cover should be installed so tha t the joints between sections are offset a minimum of 12 inches (25 mm) from the joints between sections of the Gravel Stop.
8. Adjacent sect io ns of cover are des i gn ed to overlap. No joint clip s are required.
9. Refer to detail drawings 3520 and 3530 for installation information.
Note:
Gravel Stop and metal cover are ordered separately in
10 foot lengths. They will be packaged in cardboard
tubes or wooden crates.
The cover is shipped with a protective plastic film
which should be removed prior to installation.
To clean the metal cover use soap and water (i.e.
1/3 cup laundry detergent per gallon of water).
2" (51 mm) wide
Gravel Stop with Metal Cover
(see detail 3520)
Installation:
1. Gravel Stop can be installed on any flat edge including the to p of parapet walls. The edge must be straight and even (refer to details 309 0 and 3100).
2. Attach the roofing membrane over the ed ge to hold it in place.
3. It is recommended not to use prefabricated vinyl gravel stop corners when using a metal cover.
4. Fasten the Gravel Stop to the deck or wood nailer with approved fasteners spaced 8 inches (203 mm) on center.
5. It is necessary to allow 1 inch (25 mm) spacing between each section of Gravel Stop.
6. Heat weld (hot-air) the Gravel Stop sk irt to the field membrane.
Duro-Last: The Proven Performer®
www.duro-last.com
"Duro-Last " an d T he "World's Best Roof" are registered marks owned by Duro-La st , Inc.
35
4" (102 mm) wide
Gravel Stop with Metal Cover
(see detail 3530)
800-248-0280
Revised: 12/15/2011
Loading...