Duro-Last Gravel Stop Cover User Manual

DATA SHEET
Material
Gauge
Finish
Aluminum
.032
Mill or Kynar®
Stainless Steel
24-gauge
N/A
Bonderized Steel
24-gauge
N/A
Galvalume
24-gauge
Mill or Kynar®
Copper
16 oz.
Mill
2” Gravel Stop Cover
4” Gravel Stop Cover
Description:
Manufactured from various metals (see chart
below) in 10’ lengths; 2” and 4” widths.
End-notched to provide trouble-free piece-to-
piece docking.
Ready-to-assemble inside and outside corners
are available.
Contact Duro-Last or EXCEPTIONAL® Metals to request a color chart, samples and information regarding custom metals and finishes.
Energy Efficiency:
Gravel Stop Cover
LEED® and ENERGY STAR® compliant; Recyclable.
Installation:
1. A wood nailer is required if 1” or greater of insulation is used.
2. This nailer should be attached to the wall in accordance with ANSI/SPRI ES-1 3.9.
3. Install in accordance with Duro-Last detail drawings #3100, #3520, and #3530.
4. Any deviation from the requirements set forth in the detail drawings must be pre-approved, in writing, by the EXCEPTIONAL Metals Technical Department.
Codes and Standards:
ANSI/SPRI ES-1 Compliant with 24-gauge
Galvalume cover.
FM Approved.
Warranty:
Duro-Last offers a wide range of warranty coverage for EXCEPTIONAL Metals products when used with the Duro-Last roofing system, including paint and finish.
Technical Services:
Product samples, detail sheets, color chips, and a color chart are available for your submittal package. For assistance with questions or submittals, contact your local representative or call EXCEPTIONAL Metals.
“Duro-Last” and “EXCEPTIONAL” are registered marks owned by Duro-Last Roofing, Inc. Revised 8/30/2012
Loading...