Duro-Last Fascia Cover User Manual

DATA SHEET

Material

Gauge

Finish

Aluminum

.040

Mill or Kynar®

Stainless Steel

24-gauge

N/A

Bonderized Steel

24-gauge

N/A

Galvalume

24-gauge

Mill or Kynar®

Copper

16 oz.

Mill

1-3/4” Fascia Cover

4” Fascia Cover

Fascia Cover

Description:

The 1-3/4” and 4” Fascia Cover provide a professional
finish without perimeter welding. The fascia cover is to
be used in conjunction with the Duro-Last® vinyl 1-3/4”

and 4” fascia bar.

Manufactured from various metals (see chart

below) in 10’ lengths; 1-3/4” and 4” widths.

End-notched to provide trouble-free piece-to-

piece docking.

Ready-to-assemble inside and outside corners

are available.

Contact Duro-Last or EXCEPTIONAL® Metals to
request a color chart, samples and information
regarding custom metals and finishes.

Energy Efficiency:

LEED® and ENERGY STAR® compliant; Recyclable.

Installation:

1. A wood nailer is required if 1” or greater of
insulation is used.

2. This nailer should be attached to the wall in
accordance with ANSI/SPRI ES-1 3.9.

3. Install in accordance with Duro-Last detail
drawings #3110, #3500, and #3510.

4. Any deviation from the requirements set forth in
the detail drawings must be pre-approved, in
writing, by the EXCEPTIONAL Metals Technical
Department.

Codes and Standards:

Product samples, detail sheets, color chips, and a color
chart are available for your submittal package. For
assistance with questions or submittals, contact your
local representative or call EXCEPTIONAL Metals.

ANSI/SPRI ES-1 Compliant with 24-gauge

Meets TAS 111-95 Test with 4” cover.
FM Approved.

Warranty:

Duro-Last offers a wide range of warranty coverage for
EXCEPTIONAL Metals products when used with the
Duro-Last roofing system, including paint and finish.

Technical Services:

“Duro-Last” and “EXCEPTIONAL” are registered marks owned by Duro-Last Roofing, Inc. Revised 8/30/2012

Galvalume and .040 aluminum cover.