Fascia Base shown with 2-Piece Snap-On Compression Cover.
Fascia Base
Description:
The Fascia Base functions as a fascia bar and cove
system, used with the 2-Piece Snap-On Cover. Can be
used on eaves, allowing water to flow over the roof
edge termination.
Fabricated in 10’ lengths and 3” – 8” widths.
Manufactured from 24-gauge Galvalume, 24-
gauge stainless steel, and .050 aluminum.
Contact Duro-Last® or EXCEPTIONAL® Metals to
request a color chart, samples and information
regarding custom metals and finishes.
Energy Efficiency:
LEED® and ENERGY STAR® compliant; Recyclable.
Installation:
1. A wood nailer is required if 1” or greater of
insulation is used.
2. This nailer should be attached to the wall in
accordance with ANSI/SPRI ES-1 3.9.
3. Install in accordance with Duro-Last detail
drawing #3560.
4. Any deviation from the requirements set forth in
the detail drawings must be pre-approved, in
writing, by the EXCEPTIONAL Metals Technical
Department.
Codes and Standards:
ANSI/SPRI ES-1 Compliant for 4” and 6”
base.
Warranty:
Duro-Last offers a wide range of warranty coverage for
EXCEPTIONAL Metals products when used with the
Duro-Last roofing system, including paint and finish.
Technical Services:
Product samples, detail sheets, color chips, and color
chart are available for your submittal package. For
assistance with questions or submittals, contact your
local representative or call EXCEPTIONAL Metals.
“Duro-Last” and “EXCEPTIONAL” are registered marks owned by Duro-Last Roofing, Inc. Revised 8/30/2012