Page 1
LZR/LZTR Series Remote Fixtures
Hubbell Lighting, Inc.
Installation Instructions
Halogen cycle lamps operate at high temperatures.
Do not store or place ammable materials near lamp.
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. Do not use outdoors.
2. Do not mount near heaters or hot surfaces.
3. Equipment should be mounted in locations and at heights where it will not readily be subjected to
tampering by unauthorized personnel.
4. The use of accessory equipment not authorized by the manufacturer may cause an unsafe condition.
Caution: Halogen cycle lamps are used in this equipment. To avoid shattering: Do not operate lamp in
excess of rated voltage, protect lamp against abrasion and scratches and against liquids when lamp is
operating, dispose of lamp with care.
5. Do not use this equipment for other than its intended purpose.
6. Service of this equipment should be performed by qualied service personnel.
SAVE THESE INSTRUCTIONS
Remote Lighting Fixture Installation
1. Carefully size wire conductors from
emergency unit to remote
xture(s) using a voltage
drop table.
2. Remove appropriate
knockouts in remote
xture mounting plate, feed
conductors through center hole.
3. Mount plate to approved electrical
box using screws supplied with box.
4. Make connections to xture lamp leads using wire nuts
or crimp connectors.
5. Push connectors back through hole in mounting plate
into electrical box.
6. Orient xture in desired position (xtures can be rotated
in 900 increments to four positions).
7. Set xture on backplate and tighten locking screws. Aim
lighting head(s) by rotating eyeball to desired position.
Note:
Twin head remote xtures can be mounted horizontally or vertically for more
accurate illumination.
Lamp Replacement
CAUTION: Halogen lamps operate at high temperatures.
Allow defective lamp to cool completely before attempting
replacement.
MR-16 halogen lamp
2-pin lamp socket
1. Remove plastic lamp retaining ring.
2. Pull defective lamp from lighting head assembly and
unplug lamp from socket.
3. Plug replacement lamp into socket and install lamp into
lighting head assembly.
4. Re-install lamp retainer ring (at side towards lamp).
RECYCLING INFORMATION
All thermoplastic parts are recyclable.
All cartons contain recycled materials.
Please recycle
Retaining ring
Hubbell Lighting, Inc. Life Safety Products • www.dual-lite.com
Copyright© Hubbell Lighting, Inc., All Rights Reserved • Specications subject to change without notice. • Printed in U.S.A. 0601526 D 6/11
Loading...